Cherenkov detector

From Wikipedia, the free encyclopedia
  (Redirected from Cerenkov counter)
Jump to: navigation, search

A Cherenkov (Čerenkov) detector is a particle detector using the speed threshold for light production, the speed-dependent light output or the velocity-dependent light direction of Cherenkov radiation.

Fundamental[edit]

A particle passing through a material at a velocity greater than that at which light can travel through the material emits light. This is similar to the production of a sonic boom when an airplane is traveling through the air faster than sound waves can move through the air. The direction this light is emitted is on a cone about the direction in which the particle is moving. The angle of the cone \scriptstyle \theta_c (with \scriptstyle \cos \theta_c = \frac{c}{nv}, \scriptstyle c vacuum speed of light and \scriptstyle n the refractive index of the medium) is a direct measure of the particle's speed. The Frank–Tamm formula \scriptstyle \frac{d^2N}{d\omega dx} = \frac{z^2\alpha}{c}\sin^2\theta_c gives the number of photons produced.

Aspects[edit]

Most Cherenkov detectors aim at recording the Cherenkov light produced by a primary charged particle. Some sensor technologies explicitly aim at Cherenkov light produced (also) by secondary particles, be it incoherent emission as occurring in an electromagnetic particle shower or by coherent emission, example Askaryan effect.

Cherenkov radiation is not only present in the range of visible light or UV light but also in any frequency range where the emission condition can be met i.e. in the radiofrequency range.

Different levels of information can be used. A binary information can be based on the absence or presence of detected Cherenkov radiation. The amount or the direction of Cherenkov light can be used.

In contrast to a scintillation counter the light production is instantaneous.

Detector types[edit]

In the simple case of a threshold detector the mass-dependent threshold energy allows the discrimination between a lighter particle (which does radiate) and a heavier particle (which does not radiate) of the same energy or momentum. Several threshold stages can be combined to extend the covered energy range.

Cherenkov threshold detectors have been used for fast timing and Time of flight measurements in particle physics experiments.

More elaborate designs use the amount of light produced. Recording light from both primary and secondary particles, for a Cherenkov calorimeter the total light yield is proportional to the incident particle energy.

Using the light direction are differential Cherenkov detectors.

Recording individual Cherenkov photon locations on a position-sensitive sensor area, RICH detectors then reconstruct Cherenkov angles from the recorded patterns. As RICH detectors hence provide information on the particle velocity, if the momentum of the particle is also known (from magnetic bending), combining these two informations enables the particle mass to be deduced so that the particle type can be identified.

See also[edit]