|This article does not cite any references or sources. (February 2009)|
Sometimes such a vessel will merely be called a ship in 18th to early 19th century and earlier usage, to distinguish it from other vessels such as schooners, barques, barquentines, brigs, et cetera. Alternatively, a full-rigged ship may be referred to by its function instead, as in collier or frigate, rather than being called a ship. In many languages the word frigate or frigate rig refers to a full-rigged ship.
- Foremast, which is the second tallest mast
- Mainmast, the tallest
- Mizzenmast, the third tallest
- Jiggermast, which may not be present but will be fourth tallest if so
There is no standard name for a fifth mast on a ship-rigged vessel (though this may be called the spanker mast on a barque, schooner or barquentine). Only one five-masted full-rigged ship (the Flying P-Liner Preussen) had ever been built until recent years, when a few modern five-masted cruise sailing ships have been launched. Even a fourth mast is relatively rare for full-rigged ships. Ships with five and more masts are not normally fully rigged and their masts may be numbered rather than named in extreme cases.
If the masts are of wood, each mast is in three or more pieces. They are (in order, from bottom up):
- The lowest piece is called the mast or the lower.
- Topgallant mast
- Royal mast, if fitted
On steel-masted vessels, the corresponding sections of the mast are named after the traditional wooden sections.
The lowest and normally largest sail on a mast is the course sail of that mast, and is referred to simply by the mast name: Foresail, mainsail, mizzen sail, jigger sail or more commonly forecourse etc.
Note that even a full-rigged ship did not usually have a lateral (square) course on the mizzen mast below the mizzen topmast. Instead, the lowest sail on the mizzen was usually a fore/aft sail - originally a lateen sail, but later a gaff sail called a spanker or driver. The key distinction between a "ship" and "barque" (in modern usage) is that a "ship" carries a mizzen topsail (and therefore that its mizzen mast has a topsail yard and a cross-jack yard). The cross-jack yard was the lowest yard on a ship's mizzen mast. Unlike the corresponding yards on the fore and main mast it did not usually have fittings to hang a sail from: its purpose was to control the lower edge of the topsail. In the rare case that the cross-jack yard did carry a square sail, this sail would be called the cross-jack rather than the mizzen course.
Above the course sail, in order, are:
- Topsail, or
- Lower topsail, if fitted.
- Upper topsail, if fitted.
- Topgallant sail, or
- Lower topgallant sail, if fitted.
- Upper topgallant sail, if fitted.
- Royal sail, if fitted.
- Skysail, if fitted.
- Moonraker, if fitted.
The division of a sail into upper and lower sails was a matter of practicality, since undivided sails were larger and, consequently, more difficult to handle. Larger sails necessitated hiring, and paying, a larger crew. Additionally, the great size of some late-19th and 20th century vessels meant that their correspondingly large sails would have been impossible to handle had they not been divided.
Staysails may be carried between any other mast and the one in front of it or from the foremast to the bowsprit. They are named after the mast from which they are hoisted, so for example a staysail hoisted to the top of the mizzen topgallant on a stay running to the top of the main topmast would be called the mizzen topgallant staysail.
In light winds studding sails (pronounced "stunsls") may be carried on either side of any or all of the square rigged sails except royals and skysails. They are named after the adjacent sail and the side of the vessel on which they are set, for example main topgallant starboard stu'nsail. One or more spritsails may also be set on booms set athwart and below the bowsprit.
One or two spankers are carried aft of the aftmost mast, if two they are called the upper spanker and lower spanker. A fore-and-aft topsail may be carried above the upper or only spanker, and is called the gaff sail.
To stop a full-rigged ship, the sails of the foremast are oriented in the direction perpendicular to those of the mainmast. Thus, the masts cancel out of their push on the ship. This allows the crew to stop and quickly restart the ship without retracting and lowering the sails, and to dynamically compensate for the push of the wind on the masts themselves and the yards.
See also 
- Willaumez, p.434
- "Sailing Ship Rigs" Infosheet Guide to Classic Sailing Rigs Maritime Museum of the Atlantic
- The Development of the Full-Rigged Ship From the Carrack to the Full-Rigger
- Example of full-rigged ship: Stad Amsterdam
- Christian Radich