A key frame in animation and filmmaking is a drawing that defines the starting and ending points of any smooth transition. The drawings are called "frames" because their position in time is measured in frames on a strip of film. A sequence of key frames defines which movement the viewer will see, whereas the position of the key frames on the film, video or animation defines the timing of the movement. Because only two or three key frames over the span of a second do not create the illusion of movement, the remaining frames are filled with inbetweens.
Use of key frames as a means to change parameters
In software packages that support animation, especially 3D graphics, there are many parameters that can be changed for any one object. One example of such an object is a light. (In 3D graphics, lights function similarly to real-world lights: They cause illumination, cast shadows, and create specular highlights.) Lights have many parameters including light intensity, beam size, light color, and the texture cast by the light. Supposing that an animator wants the beam size of the light to change smoothly from one value to another within a predefined period of time, that could be achieved by using key frames. At the start of the animation, a beam size value is set. Another value is set for the end of the animation. Thus, the software program automatically interpolates the two values, creating a smooth transition.
In non-linear digital video editing as well as in video compositing software, a key frame is a frame used to indicate the beginning or end of a change made to the signal. For example, a key frame could be set to indicate the point at which audio will have faded up or down to a certain level.
In video compression, a key frame, also known as an Intra Frame, is a frame in which a complete image is stored in the data stream. In video compression, only changes that occur from one frame to the next are stored in the data stream, in order to greatly reduce the amount of information that must be stored. This technique capitalizes on the fact that most video sources (such as a typical movie) have only small changes in the image from one frame to the next. Whenever a drastic change to the image occurs, such as when switching from one camera shot to another, or at a scene change, a key frame must be created. The entire image for the frame must be output when the visual difference between the two frames is so great that representing the new image incrementally from the previous frame would be more complex and would require even more bits than reproducing the whole image.
Because video compression only stores incremental changes between frames (except for key frames), it is not possible to fast forward or rewind to any arbitrary spot in the video stream. That is because the data for a given frame only represents how that frame was different from the preceding frame. For that reason it is beneficial to include key frames at arbitrary intervals while encoding video. For example, a key frame may be output once for each 10 seconds of video, even though the video image does not change enough visually to warrant the automatic creation of the key frame. That would allow seeking within the video stream at a minimum of 10 second intervals. The down side is that the resulting video stream will be larger in size because many key frames were added when they were not necessary for the visual representation of the frame. This drawback, however, does not produce significant loss of compression when the bitrate is already set at a high value for better quality (as in the DVD mpeg2 format).
- Motion Blur, Key Frames and the Fencepost Error Frames are not points in time. Frames are periods of time.
-  How to use Key frames in Sony Vegas.
-  How to detect scene changes using key frames.