Federal Aviation Regulations

From Wikipedia, the free encyclopedia
  (Redirected from Temporary Flight Restriction)
Jump to: navigation, search

The Federal Aviation Regulations, or FARs, are rules prescribed by the Federal Aviation Administration (FAA) governing all aviation activities in the United States. The FARs are part of Title 14 of the Code of Federal Regulations (CFR). A wide variety of activities are regulated, such as aircraft design and maintenance, typical airline flights, pilot training activities, hot-air ballooning, lighter-than-air aircraft, man-made structure heights, obstruction lighting and marking, and even model rocket launches, model aircraft operation, and kite flying. The rules are designed to promote safe aviation, protecting pilots, flight attendants, passengers and the general public from unnecessary risk. Since 1958, these rules have typically been referred to as "FARs", short for Federal Aviation Regulations. However, another set of regulations (Title 48) is titled "Federal Acquisitions Regulations", and this has led to confusion with the use of the acronym "FAR". Therefore, the FAA began to refer to specific regulations by the term "14 CFR part XX".[1]

Organization[edit]

The FARs are organized into sections, called parts due to their organization within the CFR. Each part deals with a specific type of activity. For example, 14 CFR Part 141 contains rules for pilot training schools. The sections most relevant to aircraft pilots and AMTs (Aviation Maintenance Technicians) are listed below. Many of the FARs are designed to regulate certification of pilots, schools, or aircraft rather than the operation of airplanes. Once an airplane design is certified using some parts of these regulations, it is certified regardless of whether the regulations change in the future. For that reason, newer planes are certified using newer versions of the FARs, and in many aspects may be thus considered safer designs.

  • Part 1 – Definitions and Abbreviations
  • Part 13 – Investigation and Enforcement Procedures
  • Part 21 – Certification Procedures for Products and Parts
  • Part 23 – Airworthiness Standards: Normal, Utility, Acrobatic and Commuter Airplanes
  • Part 25 – Airworthiness Standards: Transport Category Airplanes
  • Part 27 – Airworthiness Standards: Normal Category Rotorcraft
  • Part 29 – Airworthiness Standards: Transport Category Rotorcraft
  • Part 33 – Airworthiness Standards: Aircraft Engines
  • Part 34 – Fuel Venting and Exhaust Emission Requirements for Turbine Engine Powered Airplanes
  • Part 35 – Airworthiness Standards: Propellers
  • Part 39 – Airworthiness Directives
  • Part 43 – Maintenance, Preventive Maintenance, Rebuilding, and Alteration
  • Part 45 – Identification and Registration Marking
  • Part 47 – Aircraft Registration
  • Part 61 – Certification: Pilots, Flight Instructors, and Ground Instructors
  • Part 65 – Certification: Airmen Other Than Flight Crewmembers
  • Part 67 – Medical Standards and Certification
  • Part 71 – Designation of Class A, Class B, Class C, Class D, and Class E Airspace Areas; Airways; Routes; and Reporting Points
  • Part 73 – Special Use Airspace
  • Part 91 – General Operating and Flight Rules
  • Part 97 – Standard Instrument Approach Procedures
  • Part 101 – Moored Balloons, Kites, Unmanned Rockets and Unmanned Free Balloons
  • Part 103 – Ultralight Vehicles
  • Part 105 – Parachute Operations
  • Part 119 – Certification: Air Carriers and Commercial Operators
  • Part 121 – Operating Requirements: Domestic, Flag, and Supplemental Operations
  • Part 125 – Certification and Operations: Airplanes Having a Seating Capacity of 20 or More Passengers or a Payload Capacity of 6,000 Pounds or More
  • Part 129 – is a foreign carrier or operator of U.S. Aircraft
  • Part 133 – Rotorcraft External-Load Operations
  • Part 135 – Operating Requirements: Commuter and On Demand Operations and Rules Governing Persons on Board Such Aircraft
  • Part 136 – Commercial Air Tours and National Parks Air Tour Management
  • Part 137 – Agricultural Aircraft Operations
  • Part 139 – Certification of Airports
  • Part 141 – Flight Schools
  • Part 142 – Training Centers
  • Part 145 – Repair Stations
  • Part 147 – Aviation Maintenance Technicians Schools
  • Part 183 – Representatives of The Administrator

Regulations of interest[edit]

The FARs are divided into tens of thousands of separate sections, many of which have large numbers of researchers using them on any given day. A few of the regulations particularly interesting to laypersons, relevant to current political issues, or of historical interest are listed below.

Part 23[edit]

Part 23 contains airworthiness standards for airplanes in the normal, utility, aerobatic, and commuter categories. It dictates the standards required for issuance and change of type certificates for airplanes in these categories. E.g., the maximum takeoff weight of an airplane in the normal, utility or acrobatic category cannot exceed 12,500 lb, while in the commuter category it cannot exceed 19,000 lb.

This part has a large number of regulations to ensure airworthiness in areas such as structural loads, airframe, performance, stability, controllability, and safety mechanisms, how the seats must be constructed, oxygen and air pressurization systems, fire prevention, escape hatches, flight management procedures, flight control communications, emergency landing procedures, and other limitations, as well as testing of all the systems of the aircraft. It also determines special aspects of aircraft performance such as stall speed (e.g., for single engine airplanes – not more than 61 knots), rate of climb (not less than 300 ft/min), take-off speed (not less than 1.2 x VS1), and weight of each pilot and passenger (170 lb for airplanes in the normal and commuter categories, and 190 lb for airplanes in the acrobatic and utility categories).

The Cessna 177, Cirrus SR20 and Piper PA-34 Seneca are well-known airplanes types that were certificated to FAR Part 23.

Most of the Federal Aviation Regulations, including Part 23, commenced on February 1, 1965. Prior to that date, airworthiness standards for airplanes in the normal, utility and acrobatic categories were promulgated in Part 3 of the US Civil Air Regulations. Many well-known types of light airplane are type certificated to CAR Part 3, even though they remained in production after 1965. For example, the Cessna 150 and Piper Cherokee are type certificated to CAR Part 3.

Part 25[edit]

This part contains airworthiness standards for airplanes in the transport category.

Transport category airplanes are either:

  • Jets with 10 or more seats or a maximum takeoff weight (MTOW) greater than 12,500 pounds (5,670 kg); or
  • Propeller-driven airplanes with greater than 19 seats or a MTOW greater than 19,000 pounds (8,618 kg).

The Boeing 737 and later types, and Airbus A300 series, are well-known airplane types that were certificated to FAR Part 25.

Most of the Federal Aviation Regulations, including Part 25, commenced on February 1, 1965. Prior to that date, airworthiness standards for airplanes in the transport category were promulgated in Part 4b of the US Civil Air Regulations. The Boeing 707 and 727 are two well-known airplane types that were certificated to CAR Part 4b.

Part 27[edit]

This part contains airworthiness standards for rotorcraft in the normal category. Rotorcraft up to 7,000 lb Maximum Takeoff Weight and 9 or fewer passengers are type certified in this part.

Examples of rotorcraft certified in this part are the Schweizer 300 and the Bell 429.

Part 29[edit]

This part contains airworthiness standards for rotorcraft in the transport category. Rotorcraft with more than 20,000 lb (9,100 kg) maximum takeoff weight and 10 or more passengers must be certified to Category A standards.

Part 91[edit]

Section 91.3(b)[edit]

This regulation states that the pilot-in-command is the party directly responsible for, and is the final authority as to, an aircraft being operated.

Additionally, this regulation states that in an emergency requiring immediate action, the pilot-in-command may deviate from any regulation contained within Part 91 to the extent required to handle the emergency.

Temporary flight restrictions[edit]

Example of a presidential TFR surrounding Charleston, South Carolina.

The pertinent sections of the FAR (14 CFR Sections 91.137, 91.138, 91.139, 91.141, 91.143, 91.145, 99.7)[2][3] describe temporary flight restrictions (TFR). A TFR is a geographically-limited, short-term, airspace restriction, typically in the United States. Temporary flight restrictions often encompass major sporting events, natural disaster areas, air shows, space launches, and Presidential movements. Before the September 11, 2001 attacks, most TFRs were in the interest of safety to flying aircraft with occasional small restrictions for Presidential movements. Since 9/11, TFRs have been routinely used to restrict airspace for 30 nautical miles around the President, with a 10-nautical-mile (20 km) radius no-fly zone for non-scheduled flights. They are also available to other important people such as presidential and vice-presidential candidates (though Senator John Kerry did not ask for any TFR during the 2004 election).[4]

TFRs are deeply unpopular with pilots in the general aviation sector. Large Presidential TFRs frequently close off not only the airport Air Force One is using but nearby airports as well.[5] Others, including the Transportation Security Administration, argue that they are necessary for national security.[6]

The responsibility for screening requests for TFR and for subsequent granting or denying them, lies with the FAA's Office of System Operations Security.[7]

Two-way radio communications failure[edit]

Section 91.185 of the Federal Aviation Restrictions deals with loss of radio communications while in flight. If a loss of radio communications were to be encountered during VFR conditions, or if VFR conditions are encountered after loss of communication with the ground and other aircraft, the pilot of the aircraft shall continue the flight under VFR and land as soon as practicable. If, however, the failure occurs in IFR conditions and/or the VFR conditions are not forthcoming, the pilot should continue under the following conditions:

  • Route – The pilot will follow:
  • The route assigned in the last contact with ATC before loss of communication, or, if being radar vectored, continue direct to the radar fix specified in the vector clearance;
  • In the absence of an assigned route, the pilot will follow the route advised by ATC;
  • In the absence of an ATC assigned or advised route, the pilot will follow the route set down in the flight plan.
  • Altitude – The pilot will continue at the highest of the following altitudes or flight levels:
  • The altitude assigned in the last contact with ATC before loss of communication;
  • The minimum altitude for IFR operations;
  • The altitude advised by ATC to be expected in a further clearance.[8]

Private, commuter, and commercial[edit]

For pilots, there is an important distinction in the parts that address classes of flight. These parts do not distinguish type of aircraft, but rather type of activity done with the aircraft. Regulations for commuter and commercial aviation are far more intensive than those for general aviation, and specific training is required. Hence, flights are often referred to as Part XX operations, to specify which one of the different sets of rules applies in a particular case. Also, flight schools will often designate themselves as Part 61 or Part 141 to distinguish between different levels of training and different study programs they could offer to the students.

Part 61 is certification for private pilots, flight instructors, and ground instructors.

Part 91 is general operating rules for all aircraft. General aviation flights are conducted under this part. Part 91, Subpart (K) prescribes operating rules for fractional ownership programs.

Part 117 deals with flight and duty-time limitations and rest requirements for flightcrew members.

Part 121 is scheduled air carrier (airliners).

Part 133 is external load (helicopter) operations.

Part 135 is a set of rules with more stringent standards for commuter and on-demand operations.

Part 141 is a more structured method for pilot training, based on FAA syllabus and other standards.

Part 145 contains the rules a certificated repair station must follow as well as any person who holds, or is required to hold, a repair station certificate issued under this part.

Maintenance[edit]

Part 21 is certification procedures for products and parts.

Part 39 are airworthiness directives.

Part 43 is maintenance, preventive maintenance, rebuilding, and alteration.

Part 63 is certification for flight crewmembers other than pilots.

Part 65 is certification for airmen other than flight crewmembers.

See also[edit]

References[edit]

  1. ^ "Overview — Title 14 of the Code of Federal Regulations (14 CFR)". FAA.gov. Federal Aviation Administration. Retrieved 5 December 2013. 
  2. ^ "FAA AC 91-63C – Temporary Flight Restrictions (TFRs/TFR)". Faa.gov. 2004-05-20. Retrieved 2012-09-16. 
  3. ^ Michael W. Brown (November–December 2003). "TFR: Airspace Obstacles and TFR Trivia. A Pilot's Guide to Understanding Restrictions in Today's National Airspace System". Retrieved 2011-05-05. 
  4. ^ "No TFRs for Kerry campaign". Aircraft Owners and Pilots Association Online. 2004-08-03. Retrieved 2008-08-23. 
  5. ^ Temporary flight restrictions: President Bush travels to Rhode Island[dead link]
  6. ^ Thurber, Matt (2003-02-01). "Meet Big Brother". Aviation Maintenance. Access Intelligence, LLC. Retrieved 2008-08-23. 
  7. ^ James Williams. "We're on a Mission: Taking the Mystery Out of Temporary Flight Restrictions". FAA Safety Briefing (May/June 2011) (FAA). pp. 16–18. Retrieved 2011-05-05. 
  8. ^ "Federal Aviation Regulation Sec. 91.185 – IFR operations: Two-way radio communications failure.". Risingup.com. Retrieved September 26, 2010. 

External links[edit]