Oxygen-18

Oxygen-18, ¹⁸O

General
Symbol	18O
Names	oxygen-18, 18O, O-18, Ω, Heavy oxygen
Protons (Z)	8
Neutrons (N)	10
Nuclide data
Natural abundance	0.2%
Half-life (t1/2)	stable
Isotope mass	17.9991610 Da
Spin	0
Isotopes of oxygen Complete table of nuclides

Oxygen-18 (¹⁸
O, Ω) is a natural, stable isotope of oxygen and one of the environmental isotopes.

¹⁸
O is an important precursor for the production of fluorodeoxyglucose (FDG) used in positron emission tomography (PET). Generally, in the radiopharmaceutical industry, enriched water (H
₂¹⁸
O) is bombarded with hydrogen ions in either a cyclotron or linear accelerator, producing fluorine-18. This is then synthesized into FDG and injected into a patient. It can also be used to make an extremely heavy version of water when combined with tritium (hydrogen-3): ³
H
₂¹⁸
O or T
₂¹⁸
O. This compound has a density almost 30% greater than that of natural water.

The accurate measurements of ¹⁸
O rely on proper procedures of analysis, sample preparation and storage.

Paleoclimatology

In ice cores, mainly Arctic and Antarctic, the ratio of ¹⁸
O to ¹⁶
O (known as δ¹⁸
O) can be used to determine the temperature of precipitation through time. Assuming that atmospheric circulation and elevation has not changed significantly over the poles, the temperature of ice formation can be calculated as equilibrium fractionation between phases of water that is known for different temperatures. Water molecules are also subject to Rayleigh fractionation as atmospheric water moves from the equator poleward which results in progressive depletion of ¹⁸
O, or lower δ¹⁸
O values. In the 1950s, Harold Urey performed an experiment in which he mixed both normal water and water with oxygen-18 in a barrel, and then partially froze the barrel's contents.
The ratio ¹⁸
O/¹⁶
O (δ¹⁸
O) can also be used to determine paleothermometry in certain types of fossils. The fossils in question have to show progressive growth in the animal or plant that the fossil represents. The fossil material used is generally calcite or aragonite, however oxygen isotope paleothermometry has also been done of phosphatic fossils using SHRIMP. For example, seasonal temperature variations may be determined from a single sea shell from a scallop. As the scallop grows, an extension is seen on the surface of the shell. Each growth band can be measured, and a calculation is used to determine the probable sea water temperature in comparison to each growth. The equation for this is:

$T=A+B\cdot \left(\left(\delta {\ce {^{18}O}}\right)\overbrace {{\ce {CaCO3}}} ^{\text{calcite}}-\left(\delta {\ce {^{18}O}}\right)\overbrace {{\ce {H2O}}} ^{\text{water}}\right)$

Where T is temperature in Celsius and A and B are constants.

For determination of ocean temperatures over geologic time, multiple fossils of the same species in different stratigraphic layers would be measured, and the difference between them would indicate long term changes.

Plant physiology

In the study of plants' photorespiration, the labeling of atmosphere by oxygen-18 allows for the measurement of oxygen uptake by the photorespiration pathway. Labeling by ¹⁸
O
₂ gives the unidirectional flux of O
₂ uptake, while there is a net photosynthetic ¹⁶
O
₂ evolution. It was demonstrated that, under preindustrial atmosphere, most plants reabsorb, by photorespiration, half of the oxygen produced by photosynthesis. Then, the yield of photosynthesis was halved by the presence of oxygen in atmosphere.

¹⁸F production

Fluorine-18 is usually produced by irradiation of ¹⁸O-enriched water (H₂¹⁸O) with high-energy (about 18 MeV) protons prepared in a cyclotron or a linear accelerator, yielding an aqueous solution of ¹⁸F fluoride. This solution is then used for rapid synthesis of a labeled molecule, often with the fluorine atom replacing a hydroxyl group. The labeled molecules or radiopharmaceuticals have to be synthesized after the radiofluorine is prepared, as the high energy proton radiation would destroy the molecules.

Large amounts of oxygen-18 enriched water are used in positron emission tomography centers, for on-site production of ¹⁸F-labeled fludeoxyglucose (FDG).

An example of the production cycle is a 90-minute irradiation of 2 milliliters of ¹⁸O-enriched water in a titanium cell, through a 25 μm thick window made of Havar (a cobalt alloy) foil, with a proton beam having an energy of 17.5 MeV and a beam current of 30 microamperes.

The irradiated water has to be purified before another irradiation, to remove organic contaminants, traces of tritium produced by a ¹⁸O(p,t)¹⁶O reaction, and ions leached from the target cell and sputtered from the Havar foil.

See also

• Willi Dansgaard – a paleoclimatologist
• Isotopes of oxygen
• Paleothermometry
• Pâté de Foie Gras (short story)
• Δ18O
• Global meteoric water line