In oceanography, geomorphology, and earth sciences, a shoal is a natural submerged ridge, bank, or bar that consists of, or is covered by, sand or other unconsolidated material, and rises from the bed of a body of water to near the surface. Often it refers to those submerged ridges, banks, or bars that rise near enough to the surface of a body of water as to constitute a danger to navigation. Shoals are also known as sandbanks, sandbars, or gravelbars. Two or more shoals that are either separated by shared troughs or interconnected by past and or present sedimentary and hydrographic processes are referred to as a shoal complex.
The term shoal is also used in a number of ways that can be either similar or quite different from how it is used in the geologic, geomorphic, and oceanographic literature. Sometimes, this terms refers to either (1) any relatively shallow place in a stream, lake, sea, or other body of water; (2) a rocky area on the sea floor within an area mapped for navigation purposes; (3) a growth of vegetation on the bottom of a deep lake that occurs at any depth; (4) and as a verb for the process of proceeding from a greater to a lesser depth of water. 
Shoals are characteristically long and narrow (linear) ridges. They can develop where a stream, river, or ocean current promotes deposition of sediment and granular material, resulting in localized shallowing (shoaling) of the water. Marine shoals also develop either by the in place drowning of barrier islands as the result of episodic sea level rise or by the erosion and submergence of inactive delta lobes.
A shoal–sandbar may seasonally separate a smaller body of water from the sea, such as:
The term bar can apply to landform features spanning a considerable range in size, from a length of a few metres in a small stream to marine depositions stretching for hundreds of kilometers along a coastline, often called barrier islands.
They are typically composed of sand, although they could be of any granular matter that the moving water has access to and is capable of shifting around (for example, soil, silt, gravel, cobble, shingle, or even boulders). The grain size of the material comprising a bar is related to the size of the waves or the strength of the currents moving the material, but the availability of material to be worked by waves and currents is also important.
Wave shoaling is the process when surface waves move towards shallow water, such as a beach, they slow down, their wave height increases and the distance between waves decreases. This behavior is called shoaling, and the waves are said to shoal. The waves may or may not build to the point where they break, depending on how large they were to begin with, and how steep the slope of the beach is. In particular, waves shoal as they pass over submerged sandbanks or reefs. This can be treacherous for boats and ships.
Shoaling can also diffract waves, so the waves change direction. For example, if waves pass over a sloping bank which is shallower at one end than the other, then the shoaling effect will result in the waves slowing more at the shallow end. Thus the wave fronts will refract, changing direction like light passing through a prism. Refraction also occurs as waves move towards a beach if the waves come in at an angle to the beach, or if the beach slopes more gradually at one end than the other.
Sandbars and longshore bars
Sandbars, also known as a trough bars, form where the waves are breaking, because the breaking waves set up a shoreward current with a compensating counter-current along the bottom. Sometimes this occurs seaward of a trough (marine landform).
Sand carried by the offshore moving bottom current is deposited where the current reaches the wave break. Other longshore bars may lie further offshore, representing the break point of even larger waves, or the break point at low tide.
Harbour and river bars
Where beaches are suitably mobile, or the river’s suspended and/or bed loads are large enough, deposition can build up a sandbar that completely blocks a river mouth and damming the river. It can be a seasonally natural process of aquatic ecology, causing the formation of estuaries and wetlands in the lower course of the river. This situation will persist until the bar is eroded by the sea, or the dammed river develops sufficient head to break through the bar.
The formation of harbor bars can prevent access for boats and shipping, can be the result of:
- construction up-coast or at the harbor — e.g.: breakwaters, dune habitat destruction.
- upriver development — e.g.: dams and reservoirs, riparian zone destruction, river bank alterations, river adjacent agricultural land practices, water diversions.
- watershed erosion from habitat alterations — e.g.: deforestation, wildfires, grading for development.
- artificially created/deepened harbors that require periodic dredging maintenance.
In a nautical sense, a bar is a shoal, similar to a reef: a shallow formation of (usually) sand that is a navigation or grounding hazard, with a depth of water of 6 fathoms (11 metres) or less. It therefore applies to a silt accumulation that shallows the entrance to or course of a river, or creek. A bar can form a dangerous obstacle to shipping, preventing access to the river or harbour in unfavourable weather conditions or at some states of the tide.
Shoals as geological units
In addition to longshore bars discussed above that are relatively small features of a beach, the term shoal can be applied to larger geological units that form off a coastline as part of the process of coastal erosion. These include spits and baymouth bars that form across the front of embayments and rias. A tombolo is a bar that forms an isthmus between an island or offshore rock and a mainland shore.
In places of re-entrance along a coastline (such as inlets, coves, rias, and bays), sediments carried by a longshore current will fall out where the current dissipates, forming a spit. An area of water isolated behind a large bar is called a lagoon. Over time, lagoons may silt up, becoming salt marshes.
In some cases, shoals may be precursors to beach expansion and dunes formation, providing a source of windblown sediment to augment such beach or dunes landforms.
Since prehistoric times humans have chosen some shoals as a site of habitation. In some early cases the locations provided easy access to exploit marine resources. In modern times these sites are sometimes chosen for the water amenity or view, but many such locations are prone to storm damage.
- Ayre (landform)
- Barrier Island
- Bank (geography)
- Coastal Barrier Resources Act — 1982 U.S. law
- D Rutecki, E Nestler, T Dellapenna, and A Pembroke, 2014. Understanding the Habitat Value and Function of Shoal/Ridge/Trough Complexes to Fish and Fisheries on the Atlantic and Gulf of Mexico Outer Continental Shelf. Draft Literature Synthesis for the U.S. Dept. of the Interior, Bureau of Ocean Energy Management. Contract # M12PS00031. Bureau of Ocean Energy Management, U.S. Department of the Interior. 116 pp.
- Neuendorf, K.K.E., J.P. Mehl, Jr., and J.A. Jackson, eds. (2005) Glossary of Geology (5th ed.). Alexandria, Virginia, American Geological Institute. 779 pp. ISBN 0-922152-76-4
- W. Bascom, 1980. Waves and Beaches. Anchor Press/Doubleday, Garden City, New York. 366 p
- Mirko Ballarini, Optical Dating of Quartz from Young Deposits, IOS Press, 2006 146 pages, ISBN 1-58603-616-5
- C.Michael Hogan (2008) Morro Creek, ed. by Andy Burnham
- Dick Morris (2008) Fleeced
- Jefferson Beale Browne (1912) Key West: The Old and the New, published by The Record company