Jump to content

CGR 3rd Class 4-4-0 1884

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Andre Kritzinger (talk | contribs) at 23:23, 2 May 2016 (Tense). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

CGR 3rd Class 4-4-0 1884
Neilson works picture, c. 1884
Type and origin
Power typeSteam
DesignerCape Government Railways
(J.D. Tilney)
BuilderNeilson and Company
Serial number3080-3081
Build date1883
Total produced2
Specifications
Configuration:
 • Whyte4-4-0 (American)
Driver1st coupled axle
Gauge3 ft 6 in (1,067 mm) Cape gauge
Leading dia.27+12 in (698 mm)
Coupled dia.48+34 in (1,238 mm)
Tender wheels27+12 in (698 mm)
Wheelbase38 ft 9 in (11,811 mm) ​
 • Engine17 ft 9 in (5,410 mm)
 • Leading5 ft (1,524 mm)
 • Coupled6 ft 6 in (1,981 mm)
 • Tender9 ft 3 in (2,819 mm)
 • Tender bogie4 ft 5+12 in (1,359 mm)
Length:
 • Over couplers46 ft 2+12 in (14,084 mm)
Height12 ft (3,658 mm)
Tender weight20 LT 2 cwt 1 qtr (20,440 kg)
Tender type3-axle (1 leading, 1 bogie)
Fuel typeCoal
Fuel capacity5 LT (5.1 t)
Water cap.1,700 imp gal (7,730 L)
Firebox:
 • TypeRound-top
 • Grate area18.25 sq ft (1.695 m2)
Boiler:
 • Pitch6 ft (1,829 mm)
 • Tube plates10 ft 4+12 in (3,162 mm)
 • Small tubes143: 1+34 in (44 mm)
Boiler pressure130 psi (896 kPa)
Safety valveSalter
Heating surface:
 • Firebox83.23 sq ft (7.732 m2)
 • Tubes679.6 sq ft (63.14 m2)
 • Total surface762.83 sq ft (70.869 m2)
CylindersTwo
Cylinder size15 in (381 mm) bore
20 in (508 mm) stroke
Valve gearJoy
CouplersBell link-and-pin
Performance figures
Tractive effort9,000 lbf (40 kN) @ 75%
Career
OperatorsCape Government Railways
ClassCGR 3rd Class
Number in class2
NumbersE53-E54
Delivered1884
First run1884

The Cape Government Railways 3rd Class 4-4-0 of 1884 was a South African steam locomotive from the pre-Union era in the Cape of Good Hope.

In 1884, the Cape Government Railways placed two experimental 3rd Class tender locomotives with a 4-4-0 American type wheel arrangement in service. They were designed at the Salt River shops in Cape Town, to be able to use the low-grade local coal with its high content of incombustible matter.[1][2]

Stormberg coalfields

In 1883, the extension of the Cape Government Railways (CGR) Eastern System's line from Queenstown reached Sterkstroom and passed through the Stormberg coalfields, where the Molteno and Cyphergat mines were operating.[1][3]

While the Colonial coal was much cheaper than imported Welsh coal, it had a non-combustable content of as high as 29%. This led to difficulties when it was used in locomotives, since it frequently caused train delays as a result of unscheduled stops to allow the firemen to clear the grate of clinker and ash.[1]

J.D. Tilney

In attempts to overcome the problem, John D. Tilney, the Eastern System's Locomotive Superintendent, carried out many experiments on some of the 4th Class 4-6-0TT locomotives which had entered service on the Eastern System in 1880. One of these involved modifying the boilers and frames to accommodate oscillating firebars and larger fireboxes. He also modified approximately thirty locomotives, by installing extended fireboxes with wire netting spark arresters and steam blowers, and can be considered one of the foremost pioneers of these devices.[1][4]

Tilney's initiatives did not pass unnoticed. In 1881, the General Manager appointed Mr. Hawthorne R. Thornton as Chief Locomotive Superintendent for the whole of the Cape of Good Hope, in response to the "growing tendency on the part of the several Locomotive Superintendents to bring in modifications of designs in essential parts of the engines and rolling stock".[5]

Manufacturer

Based on the results of Tilney's experiments, complete sets of drawings for an experimental 4-4-0 American type tender passenger locomotive, as well as an experimental 4-6-0 Tenwheeler type tank-and-tender goods locomotive, were prepared at the CGR's Salt River shops in 1882 and submitted to Neilson and Company, for the construction of two 4-4-0 and four 4-6-0 locomotives.[1][2][4]

Characteristics

The locomotives were delivered with Joy valve gear. The design of the two types was also an early attempt at standardisation, since their boilers and tenders and many other parts were made interchangeable.[1][4]

The three-axle tender was unusual, since the leading axle was mounted in a rigid frame, while the other two were mounted in a bogie. This was the first time that a bogie was used under a tender in South Africa, but also the only time that this tender wheel arrangement was used on the CGR. This peculiar tender wheel arrangement appeared in South Africa on only one other occasion, eighteen years later on the Baldwin-built Zululand Railway Company 2-6-0 construction locomotive in Natal.[1][4][6]

The firebox was specially designed to Tilney's specifications, in order to cope with the high percentage of clinker and ash content of Colonial coal from the Stormberg Range. A large drop-grate, which occupied approximately half of the firebox area, with specially-designed sawtooth-shaped firebars, was arranged at the front end of the firebox. The firebars could be vibrated by a hand-operated lever in the cab, while the drop grate was controlled by two chains, fitted at each end and also manipulated from the cab.[4]

Service

The 4-4-0 locomotives entered service in 1884 and were designated 3rd Class, numbered E53 and E54 for the Eastern System. Engine no. E54 was delivered to the Eastern system, where Tilney carried out extensive tests using the Stormberg coal. Engine no. E53 was initially delivered to the Western System, for evaluation and testing by Chief Locomotive Superintendent Thornton who, in turn, experimented with coal from Viljoensdrif.[1][2][4]

The locomotives gave good results during testing and in service. It was reported at year-end in 1884 that the use of the low-grade coal led to a saving of 1¾d. per engine-mile. They were, however, difficult to fire due to their very long and narrow grates, and it was admitted in the report that dealing with the large drop-grate and the increased amount of clinker and ash, placed greater physical strain on the firemen.[4]

When better quality coal, which was more suitable for use in the standard locomotives, began to become available from the coalfields in Natal, no more locomotives of this experimental design were ordered.[1]

Both locomotives were renumbered by 1886, when the system number prefixes were done away with and the Eastern System's locomotives were renumbered into the 600 number range. Engine no. E53 became no. 645 and engine no. E54 became no. 646. Neither entered South African Railways service, since both were withdrawn from CGR service between 1900 and 1910.[1][2]

Illustration

References

  1. ^ a b c d e f g h i j Holland, D.F. (1971). Steam Locomotives of the South African Railways. Vol. 1: 1859–1910 (1st ed.). Newton Abbott, England: David & Charles. pp. 35–36. ISBN 978-0-7153-5382-0.
  2. ^ a b c d C.G.R. Numbering Revised, Article by Dave Littley, SA Rail May–June 1993, pp. 94-95.
  3. ^ The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, pp. 12-13.
  4. ^ a b c d e f g Espitalier, T.J.; Day, W.A.J. (1943). The Locomotive in South Africa - A Brief History of Railway Development. Chapter II - The Cape Government Railways (Continued). South African Railways and Harbours Magazine, December 1943. pp. 883-886.
  5. ^ Espitalier, T.J.; Day, W.A.J. (1943). The Locomotive in South Africa - A Brief History of Railway Development. Chapter II - The Cape Government Railways (Continued). South African Railways and Harbours Magazine, October 1943. pp. 731-734.
  6. ^ Dulez, Jean A. (2012). Railways of Southern Africa 150 Years (Commemorating One Hundred and Fifty Years of Railways on the Sub-Continent – Complete Motive Power Classifications and Famous Trains – 1860–2011) (1st ed.). Garden View, Johannesburg, South Africa: Vidrail Productions. p. 22. ISBN 9 780620 512282.