|Names||Farmer's loop, Wireman's knot|
|Related||Alpine butterfly knot, Artillery loop, Span loop|
|Typical use||Climbing, agriculture|
|ABoK||#1054, #1056, #2565|
The farmer's loop is a knot which forms a fixed loop. As a midline loop knot made with a bight, it is related to several other similar knots, including the alpine butterfly knot and artillery loop.
If pulled from one end and that ends continuation into the loop while not tightened it may capsize to a slip knot with a complicated and heavy knot.
It is tied on one hand to make a loop about twice the size of that hand (use fingers for a smaller one, thumb-hook-to-elbow for a large one), as follows:
- start with the rope 3 times around the palm of one hand, let the ends hang down,
- then pull the initial middle turn up from the top edge and place it over to the right
- then pull the now new middle turn up from the top edge and place it over to the left
- then pull the now new middle turn up from the top edge and place it over to the right
- then pull the now new middle turn up to form the loop, dress and tighten before use
Cornell University professor Howard W. Riley published this knot in an agricultural extension pamphlet devoted to farming knots in 1912. He was shown the knot by a farmer at the 1910 Genesee County Fair in Bativia, New York. Riley noted that he had never seen the knot described in any reference book.
- Department of the Army (2002), Field Manual No. 3-97.61 Military Mountaineering, Washington, D.C: United States Government, p. 4.16
- Ashley, Clifford W. (1944), The Ashley Book of Knots, New York: Doubleday, p. 191
- Riley, Howard W. (January 1912). "Knots, Hitches, and Splices". The Cornell Reading-Courses. Rural Engineering Series No. 1 (Ithaca, NY: New York State College of Agriculture at Cornell University) 1 (8): 1438. Retrieved 2011-11-08. As collected in Documents of the Assembly of the State of New York, 136th Session, 1913, Vol. 19, No. 29, Part 5.
|This knot-related article is a stub. You can help Wikipedia by expanding it.|