|Unit system||SI derived unit|
|Unit of||Pressure or stress|
|Named after||Blaise Pascal|
|1 Pa in ...||... is equal to ...|
|SI base units:||kg⋅m−1⋅s−2|
|US customary units||1.450377×10−4 psi|
The pascal (symbol: Pa) is the SI derived unit of pressure used to quantify internal pressure, stress, Young's modulus and ultimate tensile strength. It is defined as one newton per square meter. It is named after the French polymath Blaise Pascal.
The unit of measurement called standard atmosphere (atm) is defined as 101,325 Pa and approximates to the average pressure at sea-level at the latitude 45° N. Meteorological reports typically state atmospheric pressure in hectopascals.
The unit is named after Blaise Pascal, noted for his contributions to hydrodynamics and hydrostatics, and experiments with a barometer. The name pascal was adopted for the SI unit newton per square metre (N/m2) by the 14th General Conference on Weights and Measures in 1971.
One pascal is the pressure exerted by a force of magnitude one newton perpendicularly upon an area of one square metre.
The unit of measurement called atmosphere or standard atmosphere (atm) is 101325 Pa (101.325 kPa). This value is often used as a reference pressure and specified as such in some national and international standards, such as ISO 2787 (pneumatic tools and compressors), ISO 2533 (aerospace) and ISO 5024 (petroleum). In contrast, IUPAC recommends the use of 100 kPa as a standard pressure when reporting the properties of substances.
The Unicode computer character set has dedicated symbols U+33A9 ㎩ Square Pa and U+33AA ㎪ Square kPa in the CJK Compatibility block, but these exist for backward-compatibility with some older ideographic character-sets and are therefore deprecated.
|This section needs additional citations for verification. (January 2016) (Learn how and when to remove this template message)|
The pascal (Pa) or kilopascal (kPa) as a unit of pressure measurement is widely used throughout the world and has largely replaced the pounds per square inch (psi) unit, except in some countries that still use the imperial measurement system or the US customary system, including the United States.
In materials science and engineering, the pascal measures the stiffness, tensile strength and compressive strength of materials. In engineering use, because the pascal represents a very small quantity, the megapascal (MPa) is the preferred unit for these uses.
|nylon 6||2–4 GPa|
|hemp fibre||35 GPa|
|tooth enamel||83 GPa|
|structural steel||200 GPa|
The pascal is also equivalent to the SI unit of energy density, J/m3. This applies not only to the thermodynamics of pressurised gases, but also to the energy density of electric, magnetic, and gravitational fields.
Hectopascal and millibar units
The units of atmospheric pressure commonly used in meteorology were formerly the bar, which was close to the average air pressure on Earth, and the millibar. Since the introduction of SI units, meteorologists generally measure pressures in hectopascals (hPa) unit, equal to 100 pascals or 1 millibar. Exceptions include Canada and Portugal, which use kilopascals (kPa). In many other fields of science, the SI is preferred, which means Pa with a prefix (in multiples of 1000) is preferred.
- International Bureau of Weights and Measures (2006), The International System of Units (SI) (PDF) (8th ed.), p. 118, ISBN 92-822-2213-6
- "Definition of the standard atmosphere". BIPM. Retrieved 2015-02-16.
- U.S. Federal Meteorological Handbook
- Table 3 (Section 2.2.2), SI Brochure, International Bureau of Weights and Measures
- "Resolution 4 of the 10th meeting of the CGPM". Conférence Générale des Poids et Mesures (CGPM). 1954. Retrieved 2010-04-05.
- IUPAC.org, Gold Book, Standard Pressure
- "CJK Compatibility" (PDF). 2015. Retrieved 2016-02-21.
- "The Unicode Standard, Version 8.0.0". Mountain View, CA: The Unicode Consortium. 2015. ISBN 978-1-936213-10-8. Retrieved 2016-02-21.
- "Tensile Modulus - Modulus of Elasticity or Young's Modulus - for some common Materials". Retrieved 2015-02-16.
- "Chapter 7 ResNet Standards: ResNet National Standard for Home Energy Audits" (PDF). ResNet. 2010. Retrieved 2011-03-03.
- "KNMI - Weer - Waarnemingen". Retrieved 4 December 2016.
- "Comment convertir la pression? - IRM". Retrieved 4 December 2016.
- "Japan Meteorological Agency - Weather Maps". Retrieved 4 December 2016.
- Kingdom, Met Office, FitzRoy Road, Exeter, Devon, EX1 3PB, United. "Key to symbols and terms". Retrieved 4 December 2016.
- CTV News, weather; current conditions in Montreal
- Canada, Environment. "Montréal, QC - 7 Day Forecast - Environment Canada". Retrieved 4 December 2016.