Jump to content

New York State Route 283 (1930–1970)

Route map:
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Mitchazenia (talk | contribs) at 05:05, 1 November 2015 (pull). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

New York State Route 283 marker
New York State Route 283
Map of Tioga County with NY 283 highlighted in red and its pre-1949 extension to Pennsylvania in pink
Route information
Maintained by NYSDOT
Length7.74 mi[1][2][fn 1] (12.46 km)
Existed1930[3]–January 1, 1970[4]
Major junctions
West end NY 282 in Nichols
East end NY 17 in Owego
Location
CountryUnited States
StateNew York
CountiesTioga
Highway system
NY 282 NY 283

New York State Route 283 (NY 283) was an east–west state highway located within Tioga County in the Southern Tier of New York in the United States. It ran along the south bank of the Susquehanna River from an intersection with NY 282 in the village of Nichols to a junction with NY 17 (now NY 96 and NY 434) in the village of Owego. The route was assigned as part of the 1930 renumbering of state highways in New York as a Pennsylvania–Owego route. NY 283 was truncated to Nichols in 1949 and eliminated entirely in 1970. Its former routing is now mostly maintained by Tioga County as part of several county routes.

Route description

NY 283 began at an intersection with NY 282 in the village of Nichols, located on the southern bank of the Susquehanna River in south-central Tioga County. The route headed to the east as East River Drive, crossing over Wappasening Creek as it left the village limits. From here, the route took on a more northeasterly course, following the east side of a deep, rural valley surrounding the Susquehanna River. About 3 miles (4.8 km) from Nichols, the highway entered the small hamlet of Lounsberry, located just south of NY 283's junction with Stanton Hill Road (County Route 54 or CR 54). NY 283 continued northeast from the community, closely following the riverbank and the south edge of the encompassing valley to the village of Owego. The route served a mostly undeveloped area of the village before ending at a junction with NY 17 across the river from Owego's central business district.[5][6]

History

CR 4 approaching the Southern Tier Expressway. Until 1949, this section of highway was part of NY 283

NY 283 was assigned as part of the 1930 renumbering of state highways in New York, extending from the Pennsylvania state line southwest of the village of Nichols to NY 17 in the village of Owego. The route also served the village of Nichols, through which it overlapped with NY 282.[3] Although it was signed as a state route, the parts of NY 283 that did not overlap NY 282 were initially locally maintained.[7] On January 1, 1949, NY 283 was truncated to begin at the east end of its overlap with NY 282 in Nichols.[8] The remaining route from Nichols to Owego was split into two segments in the late 1960s as part of the Southern Tier Expressway's construction. About 2 miles (3.2 km) west of Owego, NY 283 ran along a narrow 4,000-foot (1,200 m) strip of land between the Susquehanna River to the north and a steep hill to the south. This section of NY 283 was abandoned to allow the linear strip to be used for the expressway's right of way.[9] As a result, the NY 283 designation was removed on January 1, 1970.[4]

Most of NY 283's former routing is now maintained by Tioga County as part of several county routes. From the Pennsylvania state line to NY 282 in Nichols, old NY 283 is CR 4.[1] After a brief state-maintained stretch as part of NY 282,[10][11] the former routing of NY 283 continues as CR 6 to a dead end where the road was dismantled for the Southern Tier Expressway.[1] The old route resumes about 1 mile (1.6 km) to the east as a town-maintained section of East River Drive, which feeds into CR 25 at its east end. CR 25 picks up what was once NY 283[11] and follows it into the village of Owego, connecting to NY 17 exit 64.[1] At this point, the road becomes state-maintained again as part of NY 96, which uses old NY 283 to reach NY 434 and the Susquehanna River bridge leading to the center of the village.[11]

Major intersections

The entire route was in Tioga County.

Locationmi
[1][2][fn 1]
kmDestinationsNotes
Village of Nichols0.000.00 NY 282
Village of Owego7.7412.46 NY 17Now NY 96 and NY 434
1.000 mi = 1.609 km; 1.000 km = 0.621 mi

See also

Notes

  1. ^ a b Excludes abandoned section near Owego.

References

  1. ^ a b c d e "County Roads Listing – Tioga County" (PDF). New York State Department of Transportation. August 15, 2012. Retrieved December 27, 2012.
  2. ^ a b "2011 Traffic Volume Report for New York State" (PDF). New York State Department of Transportation. September 25, 2012. p. 152. Retrieved December 27, 2012.
  3. ^ a b Tourist Map of Pennsylvania (PDF) (Map). Pennsylvania Department of Highways. 1930. Retrieved December 27, 2012.
  4. ^ a b State of New York Department of Transportation (January 1, 1970). Official Description of Touring Routes in New York State (PDF). Retrieved December 27, 2012.
  5. ^ New York (Map). Cartography by Rand McNally and Company. Mobil. 1965.
  6. ^ Owego Quadrangle – New York – Tioga Co (Map). 1:24,000. 7.5 Minute Series (Topographic). United States Geological Survey. 1969. Retrieved December 27, 2012.
  7. ^ Official Map Showing State Highways and other important roads (Map). Cartography by Rand McNally and Company. State of New York Department of Public Works. 1926.
  8. ^ "Highway Route Designations Change Jan. 1". Evening Recorder. Amsterdam, NY. Associated Press. December 9, 1948. p. 19.
  9. ^ "Along Old Rail Route". The Sunday Press. Binghamton, NY. February 20, 1966. p. 1C.
  10. ^ Barton Digital Raster Quadrangle (Map). 1:24,000. New York State Department of Transportation. 1994. Retrieved December 27, 2012.
  11. ^ a b c Owego Digital Raster Quadrangle (Map). 1:24,000. New York State Department of Transportation. 1994. Retrieved December 27, 2012.
KML is from Wikidata