Optical contact bonding
Optical contact bonding is a glueless process whereby two closely conformal surfaces are joined together, being held purely by intermolecular forces.
Isaac Newton has been credited with the first description of conformal interaction observed through the interference phenomenon known as Newton's rings, though it was S. D. Poisson in 1823 who first described the optical characteristics of two identical surfaces in contact. It was not until the 19th century that objects were made of such precision that the binding phenomenon was observed. The clinging together was described as "wringing together", or as "ansprengen" in German. By 1900 optical contact bonding was being employed in the construction of optical prisms, and the following century saw further research into the phenomenon at the same time that ideas of inter-atom interactions were first being studied.
Intermolecular forces such as Van der Waals forces, hydrogen bonds, and dipole-dipole interactions are typically not sufficiently strong to hold two apparently conformal rigid bodies together, since the forces drop off rapidly with distance, and the actual area in contact between the two bodies is small due to surface roughness and minor imperfections.
However, if the bodies are conformal to an accuracy of better than 10 angstroms (1 nanometer), then a sufficient surface area is in close enough contact for the intermolecular interactions to have an observable real world physical manifestation—that is, the two objects stick together. Such a condition requires a high degree of accuracy and surface smoothness, which is typically found in optical components, such as prisms.
Production of an optical contact bond
In addition to both surfaces' being practically conformal (in practice often completely flat), the surfaces must also be extremely clean and free from any small contamination that would prevent or weaken the bond—including grease films and specks of dust. For bonding to occur, the surfaces need only to be brought together; the intermolecular forces draw the bodies into the lowest energy conformation, and no pressure needs to be applied.
Since the method requires no binder, balsam or glue, the physical properties of the bound object are the same as the objects joined. Typically, glues and binders are more heat sensitive or have undesirable properties compared to the actual bodies being joined. The use of optical contact bonding allows the production of a final product with properties as good as the bulk solid.
|This section needs expansion. You can help by adding to it. (December 2009)|
Originally the process was confined to optical equipment such as prisms—the earliest examples being made around 1900. Later the scope of use was expanded to microelectronics and other miniaturised devices.
- Wafer bonding. Marin Alexe, U. Gösele. Page 5 google books
- More rapidly than 1/distance2
- Design and fabrication of acousto-optic devices. Akis P. Goutzoulis, Dennis R. Pape, Sergeĭ Viktorovich Kulakov page 383 google books
- Optical Contacting: Changing the Interface of Optics. Chris Myatt, Nick Traggis and Kathy Li Dessau. Precision Photonics Corporation precisionphotonics.com
- Jan Haisma, and G. A. C. M. Spierings. "Contact bonding, including direct-bonding in a historical and recent context of materials science and technology, physics and chemistry". Materials Science and Engineering: R: Reports. 37: 1–60. doi:10.1016/s0927-796x(02)00003-7.
- Description of production of experimental 'Lab on a chip' via contact bonding[dead link] RSC Publishing (Royal Society of Chemistry)
- Optical Fabrication: Optical Contacting Grows More Robust by Chris Myatt, Nick Traggis, and Kathy Li Dessau.