Demonstration model of a moving iron ammeter. As the current through the coil increases, the plunger is drawn further into the coil and the pointer deflects to the right.
|Unit system||SI base unit|
|Unit of||Electric current|
|Named after||André-Marie Ampère|
The ampere (/
The International System of Units defines the ampere in terms of other base units by measuring the electromagnetic force between electrical conductors carrying electric current. The earlier CGS measurement system had two different definitions of current, one essentially the same as the SI's and the other using electric charge as the base unit, with the unit of charge defined by measuring the force between two charged metal plates. The ampere was then defined as one coulomb of charge per second. In SI, the unit of charge, the coulomb, is defined as the charge carried by one ampere during one second.
- 1 Definition
- 2 History
- 3 Realization
- 4 Proposed future definition
- 5 Everyday examples
- 6 See also
- 7 Notes
- 8 References
- 9 External links
SI defines ampere as follows:
The ampere is that constant current which, if maintained in two straight parallel conductors of infinite length, of negligible circular cross-section, and placed one metre apart in vacuum, would produce between these conductors a force equal to ×10−7 2newtons per metre of length.
The SI unit of charge, the coulomb, "is the quantity of electricity carried in 1 second by a current of 1 ampere". Conversely, a current of one ampere is one coulomb of charge going past a given point per second:
In general, charge Q is determined by steady current I flowing for a time t as Q = It.
Constant, instantaneous and average current are expressed in amperes (as in "the charging current is 1.2 A") and the charge accumulated, or passed through a circuit over a period of time is expressed in coulombs (as in "the battery charge is 000 C"). The relation of the ampere (C/s) to the coulomb is the same as that of the 30watt (J/s) to the joule.
The ampere was originally defined as one tenth of the unit of electric current in the centimetre–gram–second system of units. That unit, now known as the abampere, was defined as the amount of current that generates a force of two dynes per centimetre of length between two wires one centimetre apart. The size of the unit was chosen so that the units derived from it in the MKSA system would be conveniently sized.
The "international ampere" was an early realization of the ampere, defined as the current that would deposit 118 grams of silver per second from a 0.001silver nitrate solution. Later, more accurate measurements revealed that this current is 85 A. 0.999
Since power is defined as the product of current and voltage, the ampere can alternatively be expressed in terms of the other units using the relationship I=P/V, and thus 1 ampere equals 1 W/V.
The standard ampere is most accurately realized using a Kibble balance, but is in practice maintained via Ohm's law from the units of electromotive force and resistance, the volt and the ohm, since the latter two can be tied to physical phenomena that are relatively easy to reproduce, the Josephson junction and the quantum Hall effect, respectively.
Proposed future definition
Rather than a definition in terms of the force between two current-carrying wires, it has been proposed that the ampere should be defined in terms of the rate of flow of elementary charges. Since a coulomb is approximately equal to 5093×1018 6.241elementary charges (such as those carried by protons, or the negative of those carried by electrons), one ampere is approximately equivalent to 5093×1018 elementary charges moving past a boundary in one second. ( 6.2415093×1018 is the reciprocal of the value of the elementary charge in coulombs. 6.241) The proposed change would define 1 A as being the current in the direction of flow of a particular number of elementary charges per second. In 2005, the International Committee for Weights and Measures (CIPM) agreed to study the proposed change. The new definition was discussed at the 25th General Conference on Weights and Measures (CGPM) in 2014 but for the time being was not adopted.
This section does not cite any sources. (October 2017) (Learn how and when to remove this template message)
The current drawn by typical constant-voltage energy distribution systems is usually dictated by the power (watt) consumed by the system and the operating voltage. For this reason the examples given below are grouped by voltage level.
CPUs – 1 V DC
- Current Notebook CPUs (up to 15...45 W at 1 V): up to 15...45 A
- Current High End CPUs (up to 65...140 W at 1,15 V): up to 55...120 A
- Hearing aid (typically 1 mW at 1.4 V): 700 µA
- USB charging adapter (as power supply - typically 10 W at 5 V): 2 A
Internal combustion engine vehicles – 12 V DC
A typical motor vehicle has a 12 V battery. The various accessories that are powered by the battery might include:
- Instrument panel light (typically 2 W): 166 mA
- Headlight (each, typically 60 W): 5 A
- Starter motor on a smaller car: 50 A to 200 A
North American domestic supply – 120 V AC
Most Canada, Mexico and United States domestic power suppliers run at 120 V.
Household circuit breakers typically provide a maximum of 15 A or 20 A of current to a given set of outlets.
- USB charging adapter (as load - typically 10 W): 83 mA
- 22-inch/56-centimeter portable television (35 W): 290 mA
- Tungsten light bulb (60–100 W): 500–830 mA
- Toaster, kettle (1.5 kW): 12.5 A
- Hair dryer (1.8 kW): 15 A
European & Commonwealth domestic supply – 230–240 V AC
Most European domestic power supplies run at 230 V, and most Commonwealth domestic power supplies run at 240 V. For the same amount of power (in watts), the current drawn by a particular European or Commonwealth appliance (in Europe or a Commonwealth country) will be less than for an equivalent North American appliance.[Note 1] Typical circuit breakers will provide 16 A.
The current drawn by a number of typical appliances are:
- Compact fluorescent lamp (11–30 W): 56–112 mA
- 22-inch/56-centimeter portable television (35 W): 145–150 mA
- Tungsten light bulb (60–100 W): 240–450 mA
- Toaster, kettle (2 kW): 9 A
- Immersion heater (4.6 kW): 19–20 A
- Ampacity (current-carrying capacity)
- Electric current
- Electric shock
- Hydraulic analogy
- Magnetic constant
- Orders of magnitude (current)
- The formula for power is given by
- "Ampère". Random House Webster's Unabridged Dictionary.
- "2. SI base units", SI brochure (8th ed.), BIPM, archived from the original on 7 October 2014, retrieved 19 November 2011
- SI supports only the use of symbols and deprecates the use of abbreviations for units."Bureau International des Poids et Mesures" (PDF). 2006. p. 130. Archived (PDF) from the original on 21 June 2007. Retrieved 21 November 2011.
- "2.1. Unit of electric current (ampere)", SI brochure (8th ed.), BIPM, archived from the original on 3 February 2012, retrieved 19 November 2011
- Base unit definitions: Ampere Archived 25 April 2017 at the Wayback Machine.. Physics.nist.gov. Retrieved on 2010-09-28.
- Bodanis, David (2005), Electric Universe, New York: Three Rivers Press, ISBN 978-0-307-33598-2
- "BIPM - ampere". www.bipm.org. Archived from the original on 26 January 2017. Retrieved 31 January 2017.
- Monk, Paul MS (2004), Physical Chemistry: Understanding our Chemical World, John Wiley & Sons, ISBN 0-471-49180-2, archived from the original on 2 January 2014
- Serway, Raymond A; Jewett, JW (2006). Serway's principles of physics: a calculus based text (Fourth ed.). Belmont, CA: Thompson Brooks/Cole. p. 746. ISBN 0-53449143-X. Archived from the original on 21 June 2013.
- Beyond the Kilogram: Redefining the International System of Units, USA: National Institute of Standards and Technology, 2006, archived from the original on 21 March 2008, retrieved 3 December 2008.
- The International System of Units (SI) (PDF) (8th ed.), Bureau International des Poids et Mesures, 2006, p. 144, archived (PDF) from the original on 5 November 2013.
- Kowalski, L, A short history of the SI units in electricity, Montclair, archived from the original on 14 February 2002
- History of the ampere, Sizes, 1 April 2014, archived from the original on 20 October 2016, retrieved 29 January 2017
- "Appendix 2: Practical realization of unit definitions: Electrical quantities", SI brochure, BIPM, archived from the original on April 14, 2013.
- "Value", Physics, USA: NIST, archived from the original on 24 April 2015.
- The NIST Reference on Constants, Units, and Uncertainty
- NIST Definition of ampere and μ0
- Tutorial video explaining amperes and current