Pocket-hole joinery

From Wikipedia, the free encyclopedia
  (Redirected from Pocket hole joinery)
Jump to: navigation, search
Pocket-hole joint being assembled.

Pocket-hole joinery, or pocket-screw joinery, involves drilling a hole at an angle — usually 15 degrees — into one workpiece, and then joining it to a second workpiece with a self-tapping screw. The technique, in addition to doweling, is said to have its roots in ancient Egypt[citation needed], although much doubt is thrown on this theory. Older woodworking reference books never mention the technique of pocket-hole joinery and contemporary woodworking references describe it as new and nontraditional.

Benefits[edit]

  • Because the screws act as internal clamps holding the joint together, glue is unnecessary (but usually recommended) for most common joints. If glue is used, clamping is not required because of the ‘internal clamps’ holding the joint together while the glue dries.
  • Requires only one hole to be drilled, eliminating the need to precisely line up mating workpieces, as is required with dowel and mortise and tenon joints.
  • Does not require any complex mathematics or measurements, such as those used in mortise and tenon joints.
  • Because pocket-hole joinery doesn't require access to the inside of the joint, quick repairs are possible without completely disassembling the joint. Fixing a squeaky chair or strengthening furniture requires only the drilling of additional pocket holes, and the use of screws to pull the two pieces together.

Drawbacks[edit]

  • Pocket-hole joints break at considerably lower weights than more traditional joinery.[1]
  • A broken pocket-hole joint "likely can’t be repaired".[2]

Applications[edit]

References[edit]