|Cookbook: Pre-ferment Media: Pre-ferment|
A pre-ferment and a longer fermentation in the bread-making process have several benefits: there is more time for yeast, enzyme and, if sourdough, bacterial actions on the starch and proteins in the dough; this in turn improves the keeping time of the baked bread, and it creates greater complexities of flavor. Though pre-ferments have declined in popularity as direct additions of yeast in bread recipes have streamlined the process on a commercial level, pre-ferments of various forms are widely used in artisanal bread recipes and formulas.
In general, there are two pre-ferment varieties: sponges, based on baker's yeast, and the starters of sourdough, based on wild yeasts and lactic-acid bacteria.[note 1] There are several kinds of pre-ferment commonly named and used in bread baking. They all fall on a varying process and time spectrum, from a mature mother dough of many generations of age to a first-generation sponge based on a fresh batch of baker's yeast:
- Biga and poolish are terms used in Italian and French baking, respectively, for sponges made with domestic baker's yeast. Poolish is a fairly wet sponge (typically one-to-one, this is, made with a one-part-flour-to-one-part-water ratio by weight), whereas biga is usually drier. Bigas can be held longer at their peak than wetter sponges, while a poolish is one known technique to increase a dough's extensibility.
- Old dough (pâte fermentée) may be made with yeast or sourdough cultures, and in essence consists of a piece of dough reserved from a previous batch, with more flour and water added to feed the remaining flora. Because this is a piece of old dough, it has the typical ingredient of salt to distinguish it from other pre-ferments.[note 2] Once old dough had rested for an additional 10 hours of age, the French named it Levain de Chef.
- Sourdough starter is likely the oldest, being reliant on organisms present in the grain and local environment. In general, these starters have fairly complex microbiological makeups, the most notable including wild yeasts, lactobacillus, and acetobacteria. They are often maintained over long periods of time. The Boudin Bakery in San Francisco for example, has used the same starter dough for over 150 years. A roughly synonymous term in French baking is levain.
- Mother dough often refers to a sourdough, and in this context the term starter often refers to all or a piece of mother dough; however, mother dough may also refer to a first-generation yeast sponge; so the process used in relation to the ingredients and fermentation times is important to understanding yeast versus sourdough methods. A roughly synonymous term used in French baking is Chef.
The common, but undocumented, origin given for the term poolish is that it was first used by Polish bakers around 1840, hence its name, and as a method was brought to France in the beginning of the 1920s. "Poolish" however is an old English version of "Polish", whereas the term seems to be most used in France (where "polonais" is the word for "Polish"). Some nineteenth-century sources use the homophone "pouliche", a French word that typically means a female foal. With either spelling, the term only appears in French sources towards the last part of the nineteenth century. There is not currently any credible explanation for the origin of the term.
A pre-ferment is easy to make and usually consists of a simple mixture of wheat flour, water, and a leavening agent (typically yeast). Two schools of thought exist regarding the inclusion of salt or sugar. They both act to inhibit or slow yeast growth, as determined by time to proof or rise, so they are not usually included and instead are added to the final dough. Ultimately, the amounts of each ingredient, and when they are added, depend on pre-ferment and final-dough formulas.
When expressed as a bakers' percentage, 50 parts of flour added to 50 parts of water or 1-to-1 is 100% hydration, and results in a relatively fluid pre-ferment. Stiffer doughs such as 50% hydration or 2-to-1, may also be used. After mixing it is allowed to ferment for a period of time, and then is added to the final dough as a substitute for or in addition to more yeast. There are distinctly different brew types of pre-ferments designed for computer-controlled bakeries that use a rather different series of ingredients, including oxidizers, needed for continuous dough-production processes.
Fermentation is sometimes performed in a warm place, or a humidity- and temperature-controlled environment. Cooler-than-room or refrigeration temperatures decelerate growth and increase the time interval, while slightly warmer temperatures accelerate growth and decrease the time interval. Too warm of a temperature slows growth, while even higher temperatures will kill the yeast. Death of the yeast cells occur in the range of 50–60 °C (122–140 °F). When cooling a levain or sourdough pre-ferment, if the dough temperature drops below 10 °C (50 °F) it affects the culture and leads to the loss of a particular aroma in the baked bread.
To allow room for the pre-ferment to rise, the ingredients are mixed in a container at least four or five times their volume. This is about the point in time when some process similarities of yeast pre-ferments to sourdough or levain starters begins to diverge. The typical amounts of time allotted for the yeast pre-ferment period may range from 2–16 hours, depending on the dough's temperature and the added amount of viable yeast, often expressed as a bakers' percentage. Spontaneous sourdough starters take, at a minimum, several days, and are subject to many variables.
To make a sourdough starter from scratch, the minimum-needed ingredients are flour, water, and time. This starter is maintained with daily feedings or refreshments of fresh flour and water or, new dough. It ferments at room temperature until the desired age or minimal number of refreshments, following a refreshment schedule that may include acceleration of time intervals leading into the final dough, then is added to the final dough. When maintaining a starter's existing weight, it is advised to discard 60% (or more) of the starter, replacing that discarded dough with new dough. If an increased amount of starter is required, simply add new dough. 40-parts-to-60-parts of old-dough-to-new-dough by weight, or 2-to-3, is known as the back-slopping ratio, and changes to that ratio change the pH of the just-refreshed dough. To make a primary-culture levain, Raymond Calvel used salt, but less of it than would be typical for many final-dough formulas.[note 3]
- Some bakers, however, use the term to refer only to the yeast variety.
- Some processes reserve a piece of pre-ferment before incorporating and mixing the remainder with the final dough, this reserved piece of old dough doesn't imply any salt content, unless it was added to the initial pre-ferment.
- When expressed as a bakers' percentage based on newly-added flour weight, Calvel's first dough included 0.5% salt and all remaining refreshments received 0.33% salt. Malt was added to only the first two sequential doughs. The back-slopping ratio expressed as old-dough-to-new-dough was in the range of 62.1-62.4%. Only the first dough rested for 22 hours. Refreshment intervals were accelerated first to 7 hours for two succeeding refreshments, then 6 hours for another three. Baker's yeast was not used. In somewhat of an oxymoronic sense this was named, "Naturally fermented sponge."
|Wikibooks Cookbook has a recipe/module on|
|Wikimedia Commons has media related to Poolish.|
- The Artisan. "Direct and Indirect Methods of Bread Baking". Retrieved 2010-04-27.
- Reinhart, Peter (2001). The bread baker's apprentice: mastering the art of extraordinary bread. Berkeley, Calif: Ten Speed Press. p. 51. ISBN 1-58008-268-8. Retrieved 2012-01-25.
- Griffin, Mary Annarose; Gisslen, Wayne (2005). Professional baking. New York: John Wiley. pp. 84–89. ISBN 0-471-46427-9. Retrieved 2012-01-25.
- Rees, Nicole; Amendola, Joseph (2003). The baker's manual: 150 master formulas for baking. London: J. Wiley. p. 33. ISBN 0-471-40525-6. Retrieved 2012-01-26.
- Daniel T. DiMuzio (2009). Bread Baking: An Artisan's Perspective. New York: Wiley. p. 142. ISBN 0-470-13882-3. Retrieved 2012-01-26.
- Reinhart, Peter (1998). Crust & Crumb: Master Formulas For Serious Bakers. Berkeley, Calif: Ten Speed Press. p. 38. ISBN 1-58008-003-0. Retrieved 2012-01-26.
- Nanna A. Cross; Corke, Harold; Ingrid De Leyn; Nip, Wai-Kit (2006). Bakery products: science and technology. Oxford: Blackwell. p. 551. ISBN 0-8138-0187-7. Retrieved 2012-01-25.
- Khachatourians, George G. (1994). Food Biotechnology: Microorganisms. New York: Wiley-Interscience. pp. 799–813. ISBN 0-471-18570-1. Retrieved 2012-01-26.
- Henry Watts, ed. (1868). A dictionary of chemistry and the allied branches of other sciences 1. London: Longmans, Green, and Company.
- Scheirlinck I, Van der Meulen R, Van Schoor A; et al. (April 2008). "Taxonomic structure and stability of the bacterial community in belgian sourdough ecosystems as assessed by culture and population fingerprinting". Appl. Environ. Microbiol. 74 (8): 2414–23. doi:10.1128/AEM.02771-07. PMC 2293155. PMID 18310426.
- Elke K. Arendt, Liam A.M. Ryana and Fabio Dal Belloa (2007). "Impact of sourdough on the texture of bread" (PDF). Food Microbiology 24 (2): 165–174. doi:10.1016/j.fm.2006.07.011. PMID 17008161. Retrieved 2012-01-25.
- Arnold L. Demain; Reinhard Renneberg (2007). Biotechnology for Beginners. Boston: Academic Press. pp. 18–19. ISBN 0-12-373581-5. Retrieved 2012-01-25.
- Esposito, Mary Ann (2003). Ciao Italia in Tuscany: traditional recipes from one of Italy's most famous regions. New York: St. Martin's Press. p. 94. ISBN 0-312-32174-0. Retrieved Aug 13, 2010.
- Calvel, Raymond (2001). The taste of bread. Gaithersburg, Md: Aspen Publishers. pp. 90–92. ISBN 0-8342-1646-9. Retrieved 2012-01-25.
- Jean Augustin Barral (1892). Dictionnaire d'agriculture ... - Google Books (in French) 4. p. 19.
- Young, Linda; Cauvain, Stanley P. (2007). Technology of Breadmaking. Berlin: Springer. p. 88. ISBN 0-387-38563-0. Retrieved April 24, 2011. See Figures 3.13 & 3.14.
- Evers, A. D.; Kent, N. (1994). Technology of cereals: an introduction for students of food science and agriculture. New York: Pergamon Press. p. 202. ISBN 0-08-040834-6. Retrieved 2012-01-26.
- Calvel, Raymond (2001). The taste of bread. Gaithersburg, Md: Aspen Publishers. p. 44. ISBN 0-8342-1646-9. Retrieved 2012-01-25.
- Wassenaar, T.; Elliott, J. "Yeast and Temperature". Retrieved 2012-01-26.
- Hsi-Mei Lai; Tze-Ching Lin (2006). Yiu H. Hui, ed. Handbook of food science, technology, and engineering 4. Washington, DC: Taylor & Francis. p. 148–11. ISBN 0-8493-9849-5. Retrieved 2012-01-29. See Figure 148.3.
- "Starch and Protein Change". Archived from the original on 2010-07-01. Retrieved 2012-02-03.