Processor supplementary capability
||This article only describes one highly specialized aspect of its associated subject. (October 2009)|
A processor supplementary capability is a feature that has been added to an existing central processing unit design after the initial introduction of that design to the marketplace.
A supplementary capability increases the usefulness of the processor design, allowing it to compete more favorably with competitors and giving consumers a reason to upgrade, while retaining backwards compatibility with the original design.
The CPU supplementary instruction capability does not as a rule apply to 8 or 16 bit CPUs, as many of these CPUs are used mostly as microcontrollers. On modern 32 and 64 bit CPUs the processor supplementary capability does not extend to Floating Point Units (FPUs) or Memory Management Units (MMUs) as these are considered to be fundamental core functionalities. Extensions to the core functionalities of the MMU and FPU may be considered CPU extensions however.
The supplementary instructions feature has always been assumed to mean fixed sets of instructions that are not obligatory across all CPUs in a CPU family. Supplementary instructions will simply not be found on all processors within that family. A programmer who wishes to use a supplementary feature of a CPU is faced with a couple of choices.
Supplemental instruction programming options
- The operating system (kernel) and systems programmer (programs) may choose to design the systems software so that it mandatorily uses that feature and therefore can only be run on the more recent processors that have that feature.
- On the other hand the system programmer may write or use existing software libraries to determine whether the processor it is running on has a particular feature (or set of instructions).
Should the needed instructions not be there a fall back to a (presumably slower or otherwise less desirable) alternative technique can be initiated or else the program may be set to run with reduced functionality.
- In other cases, an operating system may mimic the new features for older processors, though often with reduced performance.
CPU families affected
Some of these capabilities have then seen widespread adoption by programmers, spurring consumer upgrades and making the previous generations of processors obsolete.
x86 capability flags
VME Virtual 8086 Mode Enhancement DE Debugging Extensions PSE Page Size Extensions TSC Time Stamp Counter MSR RDMSR and WRMSR Support PAE Physical Address Extensions MCE Machine Check Exception CXS CMPXCHG8B Instruction (also see Double compare-and-swap and Transactional Synchronization Extensions) APIC APIC on Chip (also see APIC) MTRR Memory Type Range Register PGE PTE Global Bit (also see Page table) MCA Machine Check Architecture CMOV Conditional Move and Compare Instructions (also see FCMOV)
Supplementary Capabilities Not Represented By Flags
Processor Supplementary Instructions
Processor Supplementary Instructions are instructions that have been implemented on certain processors within a family, but are not present on all processors within a particular family.
The following instructions are considered to be processor supplementary instructions on IA-32 architecture. These instructions were added to later production processors, and are not part of the original IA-32 instruction set. Programs containing these instructions may not operate correctly on all machines in the IA-32 family:
|This section is empty. You can help by adding to it. (January 2011)|
FPU and MMU capability
The FPU (Floating Point Unit) maths co-processing capability is available on all x86 processors since the 80486DX series. The FPU and MMU instruction sets (for the x86 family) have not been considered supplementary instructions since their introduction due to their importance to core CPU functionality.