|This article needs additional or better citations for verification. (April 2012) (Learn how and when to remove this template message)|
A radiotelephone (or radiophone) is a communications system for transmission of speech over radio. Radiotelephone systems are not necessarily interconnected with the public "land line" telephone network. "Radiotelephony" means transmission of sound (audio) by radio, in contrast to radiotelegraphy (transmission of telegraph signals) or video transmission. Where a two-way radio system is arranged for speaking and listening at a mobile station, and where it can be interconnected to the public switched telephone system, the system can provide mobile telephone service.
Mode of emission
The word phone has a long precedent beginning with early US wireless voice systems. The term means voice as opposed to telegraph or Morse code. This would include systems fitting into the category of two-way radio or one-way voice broadcasts such as coastal maritime weather. The term is still popular in the amateur radio community and in US Federal Communications Commission regulations.
Modes of operation
A standard landline telephone allows both users to talk and listen simultaneously; effectively there are two open channels between the two end-to-end users of the system. In a radiotelephone system, this form of working, known as full-duplex, require a radio system to simultaneously transmit and receive on two separate channels, which both wastes bandwidth and presents some technical challenges. It is, however, the most comfortable method of voice communication for users, and it is currently used in cell phones and was used in the former IMTS.
The most common method of working for radiotelephones is half-duplex, operation, which allows one person to talk and the other to listen alternately. If a single channel is used, both ends take turns to transmit on it. An eavesdropper would hear both sides of the conversation. Dual-frequency working splits the communication into two separate channels, but only one is used to transmit at a time. The end users have the same experience as single frequency simplex but an eavesdropper with one receiver would only hear one side of the conversation.
The user presses a special switch on the transmitter when they wish to talk—this is called the "press-to-talk" switch or PTT (colloquially, sometimes called "the tit"). It is usually fitted on the side of the microphone or other obvious position. Users may use a special code-word such as "over" to signal that they have finished transmitting, or it may follow from the conversation.
Radiotelephones may operate at any frequency where they are licensed to do so, though typically they are used in the various bands between 60 and 900 MHz. They may use simple modulation schemes such as AM or FM, or more complex techniques such as digital coding, spread spectrum, and so on. Licensing terms for a given band will usually specify the type of modulation to be used. For example, airband radiotelephones used for air to ground communication between pilots and controllers operates in the VHF band from 118.0 to 136.975 MHz, using amplitude modulation.
Radiotelephone receivers are usually designed to a very high standard, and are usually of the double-conversion superhet design. Likewise, transmitters are carefully designed to avoid unwanted interference and feature power outputs from a few tens of milliwatts to perhaps 50 watts for a mobile unit, up to a couple of hundred watts for a base station. Multiple channels are often provided using a frequency synthesizer.
Receivers usually features a squelch circuit to cut off the audio output from the receiver when there is no transmission to listen to. This is in contrast to broadcast receivers, which often dispense with this.
Privacy and selective calling
Often, on a small network system, there are many mobile units and one main base station. This would be typical for police or taxi services for example. To help direct messages to the correct recipients and avoid irrelevant traffic on the network's being a distraction to other units, a variety of means have been devised to create addressing systems.
The crudest and oldest of these is called CTCSS, or Continuous Tone-Controlled Squelch System. This consists of superimposing a precise very low frequency tone on the audio signal. Only the receiver tuned to this specific tone is able to receive the signal: this receiver shuts off the audio when the tone is not present or is a different frequency. By assigning a unique frequency to each mobile, private channels can be imposed on a public network. However this is only a convenience feature—it does not guarantee privacy.
A more commonly used system is called Selective Calling or Selcall. This also uses audio tones, but these are not restricted to sub-audio tones and are sent as a short burst in sequence. The receiver will be programmed to respond only to a unique set of tones in a precise sequence, and only then will it open the audio circuits for open-channel conversation with the base station. This system is much more versatile than CTCSS, as relatively few tones yield a far greater number of "addresses". In addition, special features (such as broadcast modes and emergency overrides) can be designed in, using special addresses set aside for the purpose. A mobile unit can also broadcast a Selcall sequence with its unique address to the base, so the user can know before the call is picked up which unit is calling. In practice many selcall systems also have automatic transponding built in, which allows the base station to "interrogate" a mobile even if the operator is not present. Such transponding systems usually have a status code that the user can set to indicate what they are doing. Features like this, while very simple, are one reason why they are very popular with organisations that need to manage a large number of remote mobile units. Selcall is widely used, though is becoming superseded by much more sophisticated digital systems.
Conventional telephone use
Mobile radio telephone systems such as Mobile Telephone Service and Improved Mobile Telephone Service allowed a mobile unit to have a telephone number allowing access from the general telephone network, although some systems required mobile operators to set up calls to mobile stations. Mobile radio telephone systems before the introduction of cellular telephone services suffered from few usable channels, heavy congestion, and very high operating costs.
|This section does not cite any sources. (December 2009) (Learn how and when to remove this template message)|
The Marine Radiotelephone Service or HF ship-to-shore operates on shortwave radio frequencies, using single-sideband modulation. The usual method is that a ship calls a shore station, and the shore station's marine operator connects the caller to the public switched telephone network. This service is retained for safety reasons, but in practice has been made obsolete by satellite telephones (particularly INMARSAT) and VoIP telephone and email via satellite internet.
Short wave radio is used because it bounces between the ionosphere and the ground, giving a modest 1,000 watt transmitter (the standard power) a worldwide range.
Most shore stations monitor several frequencies. The frequencies with the longest range are usually near 20 MHz, but the ionospheric weather (propagation) can dramatically change which frequencies work best.
Single-sideband (SSB) is used because the short wave bands are crowded with many users, and SSB permits a single voice channel to use a narrower range of radio frequencies (bandwidth), about 3.5 kHz. In comparison, AM radio uses about 8 kHz, and narrowband (voice or communication-quality) FM uses 9 kHz.
Marine radiotelephony first became common in the 1930s, and was used extensively for communications to ships and aircraft over water. In that time, most long-range aircraft had long-wire antennas that would be let out during a call, and reeled-in afterward. Marine radiotelephony originally used AM mode in the 2-3 MHz region before the transition to SSB and the adoption of various higher frequency bands in addition to the 2 MHz frequencies.
One of the most important uses of marine radiotelephony has been to change ships' itineraries, and to perform other business at sea.
Some ships, including almost all military ships, carry teletypewriters, and use them to communicate over short wave. This is called "marine radiotelegraphy". The equipment is a shortwave radio transceiver with an attachment that generates and receives audio tones in order to drive the teletypewiter.
In the United States, since the Communications Act of 1934 the Federal Communications Commission (FCC) has issued various commercial "radiotelephone operator" licenses and permits to qualified applicants. These allow them to install, service, and maintain voice-only radio transmitter systems for use on ships and aircraft. (Until deregulation in the 1990s they were also required for commercial domestic radio and television broadcast systems. Because of treaty obligations they are still required for engineers of international shortwave broadcast stations.) The certificate currently issued is the general radiotelephone operator license.
- ASTRA2Connect Maritime Broadband
- AT&T High Seas Service
- Car phone
- Improved Mobile Telephone Service
- Mobile radio telephone
- Mobile Telephone Service
- Two-way radio
- Bruce, Robert V. Bell: Alexander Bell and the Conquest of Solitude. Ithaca, New York: Cornell University Press, 1990. ISBN 0-8014-9691-8.
- Carson, Mary Kay (2007). "8". Alexander Graham Bell: Giving Voice To The World. Sterling Biographies. New York: Sterling Publishing Co., Inc. pp. 76–78. ISBN 978-1-4027-3230-0. OCLC 182527281.
|Look up radiophone or radiotelephone in Wiktionary, the free dictionary.|