This article needs additional citations for verification. (February 2011) (Learn how and when to remove this template message)
|An RB.168 Mk 202 Spey as fitted to the F-4K Phantom|
|Major applications||BAC One-Eleven|
JH-7 Flying Leopard
AMX International AMX
|Developed into||Rolls-Royce Marine Spey|
The Rolls-Royce Spey (company designations RB.163 and RB.168 and RB.183) is a low-bypass turbofan engine originally designed and manufactured by Rolls-Royce that has been in widespread service for over 40 years. A co-development version of the Spey between Rolls-Royce and Allison in the 1960s is the Allison TF41.
Intended for the civilian jet airliner market when it was being designed in the late 1950s, the Spey concept was also used in various military engines, and later as a turboshaft engine for ships known as the Marine Spey, and even as the basis for a new civilian line, the Rolls-Royce Tay.
Aviation versions of the "base model" Spey have accumulated over 50 million hours of flight time. In keeping with Rolls-Royce naming practices, the engine is named after the River Spey.
- 1 Design and development
- 2 Variants
- 3 Applications
- 4 Engines on display
- 5 Specifications (Spey Mk 202)
- 6 See also
- 7 References
- 8 External links
Design and development
In 1954 Rolls-Royce introduced the first commercial bypass engine, the Rolls-Royce Conway, with a 21,000 lbf (94 kN) thrust aimed at what was then the "large end" of the market. This was far too large for smaller aircraft such as the Sud Caravelle, BAC One-Eleven or Hawker Siddeley Trident which were then under design. Rolls then started work on a smaller engine otherwise identical in design derived from the larger RB.140/141 Medway - which itself had been cancelled after British European Airways (BEA) had demanded the downsizing of the Trident, the RB.163, using the same two-spool turbine system and a fairly small fan delivering bypass ratios of about 0.64:1. Designed by a team under Frederick Morley, the first versions of what had become the 'Spey' entered service in 1964, powering both the 1-11 and Trident. Several versions with higher power ratings were delivered through the 1960s, but development was ended nearing the 1970s due to the introduction of engines with much higher bypass ratios, and thus better fuel economy. Spey-powered airliners continued in widespread service until the 1980s, when noise limitations in European airports forced them from service.
Tailored for the Buccaneer
In the late 1950s the Soviet Union started the development of the Sverdlov-class cruisers that would put the Royal Navy at serious risk. After studying the problem, the RN decided to respond in a non-linear fashion, and instead of producing a series of new cruisers themselves, they would introduce a new strike aircraft with the performance needed to guarantee successful attacks on the Soviet fleet. The winning design was the Blackburn Buccaneer, which had an emphasis on low altitude performance (to evade enemy radar) as opposed to outright speed.
Flying at low altitude, in denser air, requires much more fuel; the air-fuel mixture in a jet engine needs to be kept very close to a constant value to burn properly, and more air requires proportionally more fuel. This presented a serious problem for aircraft such as the Buccaneer, which would have had very short range unless the engines were optimised for low-level flight. The early pre-production versions, powered by the de Havilland Gyron Junior, also proved to be dangerously underpowered.
Rolls-Royce addressed this problem by offering a militarized version of the Spey, which emerged as the RB.168. The resulting Spey-powered Buccaneer S.2 served into the 1990s. The Spey proved so successful in this role that it was produced under licence in the United States as the TF41 and F113, and was used in a number of British and US designs.
The British versions of the McDonnell Douglas F-4 Phantom II (designated Phantom FG.Mk.1 and FGR.Mk.2) replaced the 16,000 lb wet thrust J79 turbojets with a pair of 20,515 lb wet thrust Spey 201 turbofans. These provided extra thrust for operation from smaller British aircraft carriers, and provided additional bleed air for the boundary layer control system for slower landing speeds. The air intake area was increased by twenty per cent, while the aft fuselage under the engines had to be redesigned. Compared to the original turbojets, the afterburning turbofans produced a ten and fifteen per cent improvement in combat radius and ferry range, respectively, and improved take-off, initial climb, and acceleration, but at the cost of a reduction in top speed because compressor outlet temperatures would be exceeded in an essentially subsonic civil design..[unreliable source?]
During its lifetime the Spey has garnered an impressive safety record. Its relatively low maintenance costs provide one of the major reasons it continued in service even when newer designs were available. With the need for a 10,000 to 15,000 lbf (44 to 67 kN) thrust class engine starting up again with the removal of the Spey from service, Rolls-Royce then used the Spey turbomachinery with a much larger fan to produce the Rolls-Royce Tay, a more modern design whose ancestors can be traced to the 1950s.
A fully updated version of the military RB.168 was also built to power the AMX International AMX attack aircraft.
- RB.163 Mk.505-5
- RB.163 Mk.505-14
- RB.163 Mk.506-5
- RB.163 Mk.506-14
- RB.163 Mk.511-8
- Gulfstream II and Gulfstream III (USAF designation F113-RR-100 for the Gulfstream C-20)
- RB.163 Mk.512-14DW
- BAC One-Eleven
- AR 963
- (RB.163) Boeing 727 (proposed); it was to have been built under licence by Allison
- US military designation for the Mk.511-8 engines fitted to the Gulfstream C-20.
- RB.168 Mk.101
- (Military Spey) Blackburn Buccaneer S2
- RB.168 Mk.202
- (Military Spey) McDonnell Douglas F-4 Phantom II modified F-4J for British service ("Phantom FG1"). (Surplus engines were purchased and used by Richard Noble for the Thrust SSC land speed record car of 1997.)
- RB.168 Mk.250
- (Military Spey) Hawker Siddeley Nimrod MR1/MR2
- RB.168 Mk.251
- (Military Spey) Hawker Siddeley Nimrod R1 and AEW
- RB.168 Mk.807
- AMX International AMX, built under licence by FiatAvio
- AR 168R
- Joint development with Allison Engine Company for the TFX competition (won by the Pratt & Whitney TF30
- RB.183 Mk 555-15 Spey Junior
- Fokker F28
- WS-9 Qinling
- Chinese license-produced copy of the RB.168 Mk.202 manufactured by the Xi'an Aero-Engine Corporation. It was used to power the Xian JH-7 and JH-7A. An improved WS-9A developing 97 kilonewtons (22,000 lbf) of thrust is reportedly in development.
- Marinised Spey delivering 18,770 shp
- Marinised Spey delivering 26,150 shp
- AMX International AMX
- BAC One-Eleven
- Blackburn Buccaneer
- Fokker F28
- Grumman Gulfstream II
- Gulfstream III
- Hawker Siddeley Nimrod MR1/R1/MR2/AEW3
- Hawker Siddeley Trident
- McDonnell Douglas Phantom FG1/FGR2
- Xian JH-7
Engines on display
This section does not cite any sources. (December 2017) (Learn how and when to remove this template message)
Examples of the Rolls-Royce Spey are on public display at the:
- Beijing Air and Space Museum
- Coventry Transport Museum
- Gatwick Aviation Museum
- Midland Air Museum
- Montrose Air Station Heritage Centre
- Royal Air Force Museum Cosford
- Royal Air Force Museum London
- Yorkshire Air Museum
Specifications (Spey Mk 202)
Data from
- Type: Low bypass turbofan
- Length: 204.9 in (5204.4 mm)
- Diameter: 43.0 in (1092.2 mm)
- Dry weight: 4,093 lb (1856 kg)
- Compressor: axial flow, 5-stage LP, 12-stage HP
- Combustors: 10 can-annular combustion chambers
- Turbine: 2-stage LP, 2-stage HP
- Maximum thrust: Dry thrust: 12,140 lbf (54 kN); with reheat: 20,500 lbf (91.2 kN)
- Air mass flow: 204lb/sec (92.53 kg/s)
- Specific fuel consumption: 1.95 lb/(lbf·h) with afterburner, 0.63 lb/(lbf·h) at military thrust
- Thrust-to-weight ratio: 5:1
- "World Encyclopedia of Aero Engines - 5th edition" by Bill Gunston, Sutton Publishing, 2006, p.197
- "Spey Powered Phantoms". Flying Review International. Volume 22 No 1: 8, 10. September 1966.
- McDonnell F-4K Phantom FG.Mk.1
- "Boeing 727" ANALYSING THE 727
- Boeing's Trimotor: BACKGROUND TO THE DEVELOPMENT OF THE 727
- "Aeroengines 1962", Flight International: 1019, 28 June 1962
- Fisher, Richard (27 May 2015). "ANALYSIS: Can China break the military aircraft engine bottleneck?". Flightglobal. Retrieved 28 May 2015.
- Gunston, Bill (2006). World Encyclopedia of Aero Engines, 5th Edition. Phoenix Mill, Gloucestershire, England, UK: Sutton Publishing Limited. ISBN 0-7509-4479-X.
|Wikimedia Commons has media related to Rolls-Royce Spey.|