Selectable Mode Vocoder

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Dcirovic (talk | contribs) at 20:49, 5 June 2016 (→‎top: refs using AWB). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Selectable Mode Vocoder (SMV) is variable bitrate speech coding standard used in CDMA2000 networks.[1] SMV provides multiple modes of operation that are selected based on input speech characteristics.

The SMV for Wideband CDMA is based on 4 codecs: full rate at 8.5 kbit/s, half rate at 4 kbit/s, quarter rate at 2 kbit/s, and eighth rate at 800 bit/s.[1] The full rate and half rate are based on the CELP algorithm[1] that is based on a combined closed-loop-open-loop-analysis (COLA). In SMV the signal frames are first classified as:

  • Silence/Background noise
  • Non-stationary unvoiced
  • Stationary unvoiced
  • Onset
  • Non-stationary voiced
  • Stationary voiced

The algorithm includes voice activity detection (VAD) followed by an elaborate frame classification scheme. Silence/background noise and stationary unvoiced frames are represented by spectrum-modulated noise and coded at 1/4 or 1/8 rate. The SMV uses 4 subframes for full rate and two/three subframes for half rate. The stochastic (fixed) codebook structure is also elaborate and uses sub-codebooks each tuned for a particular type of speech. The sub-codebooks have different degrees of pulse sparseness (more sparse for noise like excitation). SMV scores a high of 3.6 MOS[2] at full rate with clean speech.

The coder works on a frame of 160 speech samples (20 ms) and requires a look ahead of 80 samples (10 ms) if noise-suppression option B is used. An additional 24 samples of look ahead is required if noise-suppression option A is used. So the algorithmic delay for the coder is 30 ms with noise-suppression option B and 33 ms with noise-suppression option A.

The next evolution of CDMA speech codecs is VMR-WB which provides much higher speech quality with wideband while fitting to the same networks.

SMV can be also used in 3GPP2 container file format - 3G2.

References

  1. ^ a b c "3GPP2 C.S0030-0 Selectable Mode Vocoder (SMV) Service Option for Wideband Spread Spectrum Communication Systems" (PDF). 3rd Generation Partnership Project 2. 2004. Retrieved 2009-05-26.
  2. ^ J. Makinen; P. Ojala; H. Toukomaa. "Performance Comparison of Source Controlled GSM AMR and SMV Vocoders" (PDF). Nokia Research Center, Multimedia Technologies Laboratory. Retrieved 2009-05-26.

External links

  • RFC 3558 - RTP Payload Format for Enhanced Variable Rate Codecs (EVRC) and Selectable Mode Vocoders (SMV)