Jump to content

Taxiing

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Ahunt (talk | contribs) at 00:31, 31 October 2016 (Reverted edits by 68.41.200.46 (talk) to last version by BilCat). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

A privately owned Sea Vixen taxis back from an air show flight, with wings folding as it moves.
TAROM Boeing 737-300 and a United Airlines Boeing 777-200 taxi side by side at London Heathrow Airport.

Taxiing, also sometimes written "taxying", is the movement of an aircraft on the ground, under its own power, in contrast to towing or push-back where the aircraft is moved by a tug. The aircraft usually moves on wheels, but the term also includes aircraft with skis or floats (for water-based travel).

An airplane uses taxiways to taxi from one place on an airport to another; for example, when moving from a terminal to the runway. The term "taxiing" is not used for the accelerating run along a runway prior to takeoff, or the decelerating run immediately after landing.

Propulsion

The thrust to propel the aircraft forward comes from its propellers or jet engines. Reverse thrust for backing up can be generated by thrust reversers such as on the Boeing C-17 Globemaster III, or reversible pitch propellers such as on the Lockheed C-130 Hercules. Most aircraft, however, are not designed to back up on their own and must be pushed back either by hand or by using an aircraft tug.

At low power settings, combustion aircraft engines operate at lower efficiency than at cruise power settings. A typical A320 spends an average of 3.5 hours a day taxiing, using 600 litres (160 US gal) of fuel. Hybrid electrically driven nosegear are under development to allow high use aircraft to shut down the engines during taxi operations.[1]

Electric taxiing was invented by Delos Aerospace and patented in the US in 2007. Electric taxiing will significantly reduce aircraft fuel burn which is estimated to be as high as 27% of total fuel burn for a 90-minute flight where waiting in queue adds to the time on the ground. Also tire pre-spin allows for reduced impulse stress applied to the main landing gear thus extending useful lifetime for the main landing gear, and reduces tire wear, while improving passenger comfort.

Control

Aircraft on the right hand side has the right-of-way during taxiing.

Steering is achieved by turning a nose wheel or tail wheel/rudder; the pilot controls the direction travelled with their feet. Larger jet aircraft have a tiller wheel on the left side of the cockpit that acts as a steering wheel allowing the nosewheel to be turned hydraulically. Braking is controlled by differential toe or heel brakes. Not all aircraft have steerable wheels, and in some cases steering is solely by means of differential braking (all Van's aircraft for instance) or solely by means of the rudder (including all floatplanes).

Hover taxi

A Eurocopter EC120B hover-taxis

Skid-equipped helicopters and other VTOL (Vertical Take-Off and Landing) aircraft conduct hover taxiing to move in ground effect in the same manner that wheel-equipped aircraft ground taxi. In general hover taxis are conducted at speeds up to 20 kn (37 km/h), or below translational lift.[2]

The Bell CH-135 Twin Huey is hover taxied in a manner typical for skid-equipped aircraft of that size:

This sequence is initiated from a stabilized 5 ft hover. Move the aircraft forward over the ground at a brisk walking pace. Maintain a constant height above ground, constant forward speed and ensure that the skids remain parallel to the direction of movement. Anticipate stopping so that large rearward cyclic applications are not required as this may result in the tail skids striking the ground. You are often required to taxi out of wind; be aware that when taxiing downwind in strong wind conditions there may be insufficient rearward cyclic to ensure adequate control and that the tail will be nearer the ground. Taxiing downwind is limited to 30 kts.[3]

Safety

When taxiing, aircraft travel slowly. This ensures that they can be stopped quickly and do not risk wheel damage on larger aircraft if they accidentally turn off the paved surface. Taxi speeds are typically from 5 to 20 knots (9 to 37 km/h; 6 to 23 mph).[4][5]

Rotor downwash limits helicopter hover-taxiing near parked light aircraft.

The use of engine thrust near terminals is restricted due to the possibility of jet blast damage.

See also

References

  1. ^ "Innovation Focuses on A320 Taxi Burn". Retrieved 22 April 2011.(subscription required)
  2. ^ Crane, Dale: Dictionary of Aeronautical Terms, third edition, page 263. Aviation Supplies & Academics, 1997. ISBN 1-56027-287-2
  3. ^ 10 Tactical Air Group: CFACM 40-35 CH-135 Standard Maneuver Guide, page 1-1, section 103 Taxiing (unclassified). Canadian Forced Air Command, 1984
  4. ^ "A Statistical Learning Approach to the Modeling of Aircraft Taxi-Time" (PDF). Retrieved 2014-04-25.
  5. ^ "Ramp-age". Cargolaw.com. 2003-01-19. Retrieved 2014-04-25.