|This article needs additional or better citations for verification. (September 2008) (Learn how and when to remove this template message)|
A word clock or wordclock (sometimes sample clock, which can have a broader meaning)[further explanation needed] is a clock signal used to synchronise other devices, such as digital audio tape machines and compact disc players, which interconnect via digital audio. S/PDIF, AES/EBU, ADAT, and TDIF are some of the formats that use a word clock. Various audio over Ethernet systems use broadcast packets to distribute the word clock. The device which generates the word clock - usually with multiple output connectors - is the only master clock source for all the slave audio devices.
Word clock is so named because it clocks each sample. Samples are represented in data words.
Comparison to timecode
Word clock should not be confused with timecode; word clock is used entirely to keep a perfectly timed and constant bitrate to avoid data errors. Timecode is actual data (technically metadata) about the media being transmitted, and is optional, being sent in a higher layer. Time code can be used as an initial phase reference for jam sync using the word clock as the frequency reference.
Word clock over coax cable
Professional digital audio equipment may have a word clock input or output to synchronize timing between multiple devices. Although the electrical characteristics of the word clock signal have not been completely standardized, some characteristics should always apply. Things that should remain consistent are TTL level, a 75ohm output impedance, 75ohm cables and a 75ohm terminating resistor at the end of a chain or cable.
Proper termination of the word clock signal with a 75ohm resistor is important. It prevents the clock signal from reflecting back into the cable and causing false detection of extra 1's and 0's. Some digital equipment include a switchable terminator, some include a hardwired terminator and others have no terminator at all. The unfortunate part is that some equipment manuals do not indicate whether a hardwired terminator is included or not.
The chain connection from the source (master) to the receivers (slaves) may increase jitter. Using clock distributing devices for parallel transmission is a better way. The length and quality of coaxial cables are important.