Jump to content

Mechanical vapor recompression

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Mvr2022 (talk | contribs) at 05:22, 20 October 2022. The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Mechanical vapor recompression (MVR) is an energy recovery process which can be used to recycle waste heat to improve efficiency.[1][2] Typically, the compressed vapor is fed back to help heat the mother liquor in order to produce more vapor or steam.

Applications

Current

Mechanical vapor recompression is used chiefly in industrial processes such as evaporation and distillation. Heat from the condenser, which would otherwise be lost, can be recovered and used in the evaporation process.

Past

MVR was successfully tested in a locomotive under the name of "The Anderson System". Testing found that it almost completely eliminated steam ejection, as well as greatly reduced operating noise. An observer of the test wrote the following:

"In the ordinary way this would have created much noise and clouds of steam, but with the condensing set in action it was all absorbed with the ease with which snow would melt in a furnace! The engine was as silent as an electric locomotive and the only faint noises were due to slight pounding of the rods and a small blow at a piston gland. This had to be experienced to be believed; but for the regulator being wide open and the reverser well over, one would have imagined that the second engine (an LSWR T14 class that had been provided as a back-up) was propelling the first".[3]

The trials continued until 1934 but various problems arose and the project went no further. The locomotive was converted back to standard form in 1935.[4]

MVR was also used in the Cristiani compressed steam system for locomotive transmission. Although it was technically feasible, it failed to become popular because of its complexity.[5]

Alternatives

Alternatives to mechanical vapor recompression (MVR) are:

A combination of the three methods may be used depending on the process. For instance, a 3-effect evaporator circuit may be installed using MVR to transfer heat.


References

  1. ^ https://www.energy.gov/sites/prod/files/2014/05/f16/steam11_waste_steam.pdf [bare URL PDF]
  2. ^ "Steam Compression".
  3. ^ Robertson, Kevin, Leader and Southern Experimental Steam, Alan Sutton Publishing 1990, pp 22-33, ISBN 0-86299-743-7
  4. ^ Douglas Self (2008-04-01). "The Holcroft-Anderson Recompression Locomotive". Retrieved 2012-02-12.
  5. ^ "The Cristiani Compressed Steam System".