Jump to content

Active filter

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 75.19.73.101 (talk) at 01:50, 17 December 2007 (variety --> topology (more specific); when listing advantages, point out what exactly it's being compared to; active voice.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

An example of high-pass active filter of the Sallen Key topology. The operational amplifier, U1, is used as a buffer amplifier.

An active filter is a type of analog electronic filter, distinguished by the use of one or more active components i.e. voltage amplifiers or buffer amplifiers. Typically this will be a vacuum tube, transistor or operational amplifier.

Active filters have two main advantages over passive filters. The first is that the amplifier powering the filter can be used to shape the filter's response, e.g., how quickly and how steeply it moves from its passband into its stopband. (To do this passively, one must use inductors, which tend to pick up surrounding electromagnetic signals and are often quite physically large.) The second is that the amplifier powering the filter can be used to buffer the filter from the electronic components it drives. This is often necessary so that they do not affect the filter's actions.

Active filter circuit configurations (electronic filter topology) include:

There are several varieties of active filter. Some of them, also available in passive form, are:

  • High-pass filters – attenuation of frequencies below their cut-off points.
  • Low-pass filters – attenuation of frequencies above their cut-off points.
  • Band-pass filters – attenuation of frequencies both above and below those they allow to pass.
  • Notch filters – attenuation of certain frequencies while allowing all others to pass.

To design filters, different types are available to set the component value based on mathematical properties (which define "shape" of the frequency bands)