Motorcycle tyre

A rear motorcycle tyre for street use

Studded front tyre with spikes used on Ice speedway

Motorcycle tyres provide the only contact with the ground, via the contact patch under normal conditions, and so have a very large influence over motorcycle handling characteristics. Motorcycle tyres have a round cross section to facilitate the leaning necessary when a motorcycle turns. The unworn portion of tyre near the outer edge my be referred to as chicken strips.

Motorcycles mainly use pneumatic tyres. However, in some cases where punctures are common (some enduros), the tyres are filled with a "mousse" which is unpunctureable. Both types of tyre come in many configurations.

Types

Motorcycle tyres are available for many different applications, including: Sport, Sport Touring, Touring, Cruiser, Scooter, On/Off Road, Dual-Sport, Enduro, Motocross and Racing. There are tyres designed for dirtbikes, touring, sport and cruiser bikes.

Sport/performance tyres provide amazing grip but may last 1,000 miles (1,600 km) or less. Cruiser and "sport touring" tyres try to find the best compromise between grip and durability. There is also a type of tyre developed specifically for racing. These tyres offer the highest of levels of grip for cornering. Because of the high temperatures at which these tyres typically operate, use on the street is unsafe because the tyres will typically not reach optimum temperature before a rider arrives at the destination, thus providing almost no grip en route. In racing situations, racing tyres would normally be brought up to temperature in advance by the use of tyre warmers.

Sport Touring tyres are generally not used for high cornering loads, but for long straights, good for riding across the country.

Sport Street tyres are for aggressive street riders that spend most of their time carving corners on public roadways. These tyres do not have a long life, but in turn have better traction in high speed cornering. Street and sport street tyres have good traction even when cold, but when warmed too much, can actually lose traction as their internal temperature increases.

Track or Slick tyres are for track days or races. They may have more of a triangular profile, which in turn gives a larger contact patch while leaned over. These tyres are not recommended for the street by manufactures, and are known to have a shorter life on the street. Due to the triangulation of the tyre, there will be less contact patch in the centre, causing the tyre to develop a flat spot quicker when used to ride on straightaways for long periods of time and have no tread so they lose almost all grip in the wet. Racing slicks are always made of a softer rubber compound and do not provide as much traction as street tyres until warmed to a higher internal temperature than street tyres normally operate at. Most street riding will not put a sufficient amount of friction on the tyre to maintain the slick's optimal tyre temperature, especially in colder climates and in spring and fall.

Off road tyres have knobbly, deep treads for maximum grip on loose dirt, mud, sand, or gravel; such tyres tend to be less stable on paved surfaces.

Touring tyres are usually made of harder rubber for greater durability. They may last longer, but they tend to provide less outright grip than sports tyres at optimal operating temperatures. The tradeoff is that touring tyres typically offer more grip at lower temperatures, meaning they can be more suitable for riding in cold or winter conditions whereas a sport tyre may never reach the optimal operating temperature.

Speed and construction

As with four-wheeled vehicles, tyres for motorcycle have a tyre code, which describes a tyre's width, height/width aspect ratio, wheel diameter, load index and speed rating. The most common are:

• 3 digit number: The "nominal section width" of the tyre in millimetres; the widest point from both outer edges.
• /: Slash character for character separation.
• 2 or 3 digit number: The "aspect ratio" of the sidewall height to the total width of the tyre, as a percentage.
• An optional letter indicating construction of the fabric carcass of the tire:
  • B: bias belt (where the sidewalls are the same material as the tread, leading to a rigid ride)
  • D: diagonal
  • R: radial
    • if omitted, then it is a cross ply tyre
• 2 digit number: Diameter in inches of the wheel that the tyre is designed to fit.
• 2 or 3 digit number: Load index; see table below
• 1 or 2 digit/letter combo: Speed rating; see table below

Load index

LI	kg	LI	kg	LI	kg	LI	kg	LI	kg
19	77,5	36	125,0	53	206	70	335,0	87	545,0
20	80,0	37	128,0	54	212,0	71	345,0	88	560,0
21	82,5	38	132,0	55	218,0	72	355,0	89	580,0
22	85,0	39	136,0	56	224,0	73	365,0	90	600,0
23	87,5	40	140,0	57	230,0	74	375,0	91	615,0
24	90,0	41	145,0	58	236,0	75	387,0	92	630,0
25	92,0	42	150,0	59	243,0	76	400,0	93	650,0
26	95,0	43	155,0	60	250,0	77	412,0	94	670,0
27	97,5	44	160,0	61	257,0	78	425,0	95	690,0
28	100,0	45	165,0	62	265,0	79	437,0	96	710,0
29	103,0	46	170,0	63	272,0	80	450,0	97	730,0
30	106,0	47	175,0	64	280,0	81	462,0	98	750,0
31	109,0	48	180,0	65	290,0	82	475,0	99	775,0
32	112,0	49	185,0	66	300,0	83	487,0	100	800,0
33	115,0	50	190,0	67	307,0	84	500,0	-	-
34	118,0	51	195,0	68	315,0	85	510	-	-
35	121,0	52	200,0	69	325	86	530,0	-	-

Speed rating

Rating	Speed (km/h)	Speed (mph)
Moped	50	30
J	100	62
K	110	69
L	120	75
M	130	81
P (or-)	150	95
Q	160	100
R	170	105
S	180	113
T	190	118
U	200	125
H	210	130
V	240	150
W	270	168
ZR	over 240	over 150

Safety

Worn tyres influence the handling of a motorcycle and thereby reduce the performance required for safe riding. The recommended minimum tread depth is 2mm.

See also

• Bicycle tire
• Camber thrust
• Pneumatic trail
• Outline of motorcycles and motorcycling