Jump to content

Clair–Fort Kent Bridge

Coordinates: 47°14′57.3″N 68°36′13.6″W / 47.249250°N 68.603778°W / 47.249250; -68.603778
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 50.193.171.70 (talk) at 15:44, 10 December 2012 (Well, did they or didn't they??). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Clair – Fort Kent Bridge
Coordinates47°14′57″N 68°36′14″W / 47.24925°N 68.60378°W / 47.24925; -68.60378
CrossesSaint John River
LocaleCanada–United States border
OwnerState Highway Agency
Maintained byState Highway Agency
ID number2398
Characteristics
DesignTruss - Thru
MaterialSteel beams
Total length221.93 m (728.1 ft)
Width12.2 m
No. of spans3
Load limitM 18
Clearance above1.5 m
History
Construction start1929
Construction end1930
Replacescable ferry, cable suspension footbridge
Statistics
Daily traffic958 (2010)

The Clair – Fort Kent Bridge is a steel truss bridge crossing the Saint John River between Clair, New Brunswick in Canada and Fort Kent, Maine in the United States.

The bridge handles approximately 279,490 vehicle crossings per year and forms a border crossing on the International Boundary. It connects with Route 205 in New Brunswick and Route 161 and U.S. Route 1 in Maine, also forming the northern terminus of Route 1.

Since it is an international bridge, the Canadian portion of the structure is the responsibility of the Province of New Brunswick, while the American portion is operated by the State of Maine. The bridge was built in 1929–30 as a replacement for an existing cable ferry and a cable suspension footbridge. There are three steel trough-truss spans of 73.15 m (240.0 ft) each for a total length of 221.93 m (728.1 ft).

In 1995, the 1st pier from the New Brunswick abutment had major repairs done. In 1997, the steel members under the deck in the first 1.5 spans from the New Brunswick end were sandblasted then painted with a primer of inorganic zinc. In the same year the downstream exterior stringers in these 1.5 spans was replaced. In 1998, the downstream concrete curb in the first 1.5 spans from the New Brunswick end was replaced. In 2000, the New Brunswick end concrete abutment underwent a major restoration.

Planned Replacement

In January 2011, the Maine Department of Transportation imposed a 2.7 ton weight restriction on the bridge after advanced deterioration of the bridge on Maine's side was discovered during a routine inspection. On January 28, 2011, officials from New Brunswick and Maine announced plans to build a new bridge and demolish the existing structure. Construction was expected to begin before the end of 2011, after environmental studies are finished.[1]

47°14′57.3″N 68°36′13.6″W / 47.249250°N 68.603778°W / 47.249250; -68.603778

References