Jump to content

0 to 60 mph

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 205.178.29.163 (talk) at 19:23, 28 April 2013 (Removed nonsense about v-max 0-60 time). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

The time it takes to accelerate from 0 to 60 mph (0 to 97 km/h or 0 to 27 m/s) is a commonly used performance measure for automotive acceleration in the United States and the United Kingdom. In the rest of the world 0 to 100 km/h (0 to 62 mph) is used. Present performance cars are capable of going from 0 to 60 mph in under 6 seconds, while exotic cars can do 0 to 60 mph in between 3 and 4 seconds, whereas motorcycles have been able to achieve these figures with sub-500cc engine for more than 20 years. The Bugatti Veyron Super Sport is currently the fastest production street legal car to reach 60 mph from a stop, reaching the speed in 2.46 seconds,[1].

Criticism of magazine testing

Automobile magazines often post 0-60 mph times that they achieve in testing. Many have questioned the practices and methods used to test the automobiles. Typically criticism revolves around:

  • "Roll out" here the car is allowed to roll for a certain amount of time or distance before the timing begins.[2]
  • General conditions: Air temperature, altitude, fuel level, etc.
  • "Factory Freaks" which would be abnormally quick stock automobiles
  • The public's inability to achieve such low times
  • High level of differences between magazines
  • Possible bribery or other unethical practices of the testers
  • Optimizing the car's performance by making setup changes such as tire pressure
  • The ability of the particular driver
  • Using unconventional gearing, by where the drive does shift but uses a low gear only just capable of reaching the desired speed.

See also

References

  1. ^ "Bugatti Veyron test". Retrieved 2008-01-09.
  2. ^ "2006 Cadillac test". Retrieved 2008-01-09. {{cite web}}: Check |archiveurl= value (help)