Jump to content

Slide plate

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Mindfrieze (talk | contribs) at 21:41, 28 April 2017 (Refined category.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

A slide plate is linear bearing such as may be part of the expansion joints of bridges, high temperature horizontal ducts of water-tube boilers and other mechanical or structural engineering applications. In each case one plate is fixed and the other slides on top as expansion or contraction occurs.

The plates provide a surface with a low coefficient of friction which can be attached to a supporting structure. This combination provides support while simultaneously allowing an object to move (slide) freely along the supporting surface.[1] The plate may be of polytetrafluoroethylene (PTFE),TEF-MET,[2] Lubrite[3] or steel according to the application.

Multiple design variations are possible but the most common example of a slide plate (in structural applications) has glass-filled PTFE [4] bonded to a steel backing plate. In these applications a two-part system is used which has an upper element with stainless steel surface face-down and bearing on a lower element with its PTFE steel backing surface face-up.[5] In most applications, the upper element is larger than the lower element by the amount of movement expected. This has a two-fold advantage of maintaining a constant bearing area and preventing the lower surface from being exposed to dirt, grit or other contaminants throughout the range of motion.[6]

Slides plates are arranged in a 'sandwich' formation, which is made of an upper slide plate and a lower slide plate component.[7]

Commonly used in [8]

  • Oil/gas/chemical industries
  • Complex steel structures
  • Post-tensioned concrete structures

See also

References