Jump to content

Hip prosthesis zones

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by KolbertBot (talk | contribs) at 16:50, 31 August 2017 (Bot: HTTP→HTTPS). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Zones of a hip prosthesis, by the DeLee and Charnley system,[1] and the Gruen system.[2]

After hip replacement, hip prosthesis zones are regions in the interface between prosthesis material and the surrounding bone. These are used as reference regions when describing for example complications including hip prosthesis loosening on medical imaging. Postoperative controls after hip replacement surgery is routinely done by projectional radiography in anteroposterior and lateral views.

DeLee and Charnley

The DeLee and Charnley system applies to the acetabular cup on anteroposterior radiographs. It divides the acetabulum into three equally large zones.[1]

Gruen

The Gruen zones is a system of dividing the interface between the bone and the stem of the hip prosthesis.

Zone Description
I Greater trochanter
II
III
IV Distal to tip
V
VI
VII Lesser trochanter

References

  1. ^ a b Page 958 in John J. Callaghan, Aaron G. Rosenberg, Harry E. Rubash (2007). The Adult Hip, Volume 1. Lippincott Williams & Wilkins. ISBN 9780781750929.{{cite book}}: CS1 maint: multiple names: authors list (link)
  2. ^ Neumann, Daniel R.P.; Thaler, Christoph; Hitzl, Wolfgang; Huber, Monika; Hofstädter, Thomas; Dorn, Ulrich (2010). "Long-Term Results of a Contemporary Metal-on-Metal Total Hip Arthroplasty". The Journal of Arthroplasty. 25 (5): 700–708. doi:10.1016/j.arth.2009.05.018. ISSN 0883-5403.

Further reading

Gruen, TA; McNeice, GM; Amstutz, HC (1979). "Modes of failure of cemented stem-type femoral components: a radiographic analysis of loosening". Clin Orthop Relat Res. 141: 17–27. PMID 477100.