Jump to content

Scania 3-series (bus)

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 82.25.131.153 (talk) at 22:12, 5 February 2018. The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Scania 3-series
Carrus Fifty bodied Scania K113TLB in Sweden.
Overview
ManufacturerScania
Production1988-1999
Assembly
Body and chassis
ClassBus chassis
Body styleSingle-decker bus
Single-decker coach
Double-decker bus
Articulated bus
Doors1 to 4
Floor typeStep entrance
Powertrain
Engine
  • 8.5 L DS9/DSC9 I6 (diesel)
  • 11.0 L DS11/DSC11 I6 (diesel)
Chronology
PredecessorScania 2-series
SuccessorScania 4-series

The Scania 3-series bus range was introduced by Scania in 1988 and was superseded by the 4-series bus range in 1999.[1]

Model designations

The model designation breakdown is as follows:

Main type
  • F: chassis with engine located longitudinally in front of the front axle
  • S: chassis with engine located longitudinally above the front axle
  • K: chassis with engine located longitudinally behind the rear axle
  • L: chassis with engine located longitudinally behind the rear axle, inclined 60° leftward
  • N: chassis with transverse engine located behind the rear axle
  • CN: complete bus based on N-chassis
  • CK: complete bus based on K-chassis
  • CL: complete bus based on L-chassis
Engine series
  • 9: DS9 or DSC9 series 8.5-litre engine
  • 11: DS11 or DSC11 series 11-litre engine
Development code
  • 3: third generation
Chassis type
  • A: chassis for articulated bus
  • C: chassis for single-decker, two-axle bus
  • D: chassis for double-decker bus
  • N: F-chassis for heavy-duty execution
  • T: chassis for single-decker or double-decker bus with trailing axle
Steering wheel location
  • L: left-hand drive
  • R: right-hand drive
Axle/suspension configuration
  • A: K-chassis: independent front suspension
  • B: K-chassis: rigid front axle, N-chassis: independent front suspension
  • L: N-chassis: rigid front axle

So K113TLA would be a left-hand drive tri-axle coach with independent front suspension, while L113CRL would be a right-hand drive two-axle citybus.

Scania F93/F113

The F93 and F113 chassis had the engine mounted in front of the front axle. These models were not sold in Europe. These was made and sold in Argentina (only the F113[2]) and Brazil (the two models).

Scania K93/K113

Murrays Austral Pacific bodied Scania K113TRBL 14.5-metre quad-axle coach in Canberra, Australia

The K93 and K113 were the most common chassis for coaches, with a longitudinally rear-mounted engine.

It was even available as the rare quad-axle K113TRB in Australia.

Scania L113

Scania N113

Scania S113

The S113 chassis had the engine mounted above the front axle. It was not sold in Europe. The S113 was discontinued in 1993.

References