Jump to content

Roland OP-8

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Plandu (talk | contribs) at 19:30, 28 March 2018 (edited citations to remove an error). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

The Roland OP-8 interface was designed to control Roland polyphonic synthesizers that were equipped with a DCB (Digital Control Bus) interface via the Roland MC-4 Microcomposer.[1] The OP-8 and synthesizer were connected together usin a DCB cable. The OP-8 and MC-4 Microcomposer were then patched together using patchcords via each of their patchbays.[1] The transpose control on the OP-8 was able to transpose the synthesizer up or down by one octave.[1]

DCB Equipped Synthesizers

The Jupiter 8 needed minor changes in its circuit for setting up with the OP-8. This work was carried out by Roland.[1]

When using the OP-8 with a Roland Juno 60 the connection and operation were extremely easy, as only the CV and gate input jacks, and the transpose switch were relevant.[1]

References

  1. ^ a b c d e Roland OP-8 Operation Manual