Data terminal equipment
This article needs additional citations for verification. (July 2013) |
![](http://upload.wikimedia.org/wikipedia/commons/thumb/9/99/DEC_VT100_terminal.jpg/220px-DEC_VT100_terminal.jpg)
![](http://upload.wikimedia.org/wikipedia/commons/thumb/2/2a/EIA_232_DTE_DCE_DCE_DTE.png/500px-EIA_232_DTE_DCE_DCE_DTE.png)
Data terminal equipment (DTE) is an end instrument that converts user information into signals or reconverts received signals. These can also be called tail circuits. A DTE device communicates with the data circuit-terminating equipment (DCE). The DTE/DCE classification was introduced by IBM.
A DTE is the functional unit of a data station that serves as a data source or a data sink and provides for the data communication control function to be performed in accordance with the link protocol.
Usually, the DTE device is the terminal (or a computer emulating a terminal), and the DCE is a modem or another carrier-owned device. The data terminal equipment may be a single piece of equipment or an interconnected subsystem of multiple pieces of equipment that perform all the required functions necessary to permit users to communicate. A user interacts with the DTE (e.g. through a human-machine interface), or the DTE may be the user.
Connections
Two different types of devices are assumed on each end of the interconnecting cable for a case of simply adding DTE to the topology (e.g. to a hub, DCE), which also brings a less trivial case of interconnection of devices of the same type: DTE-DTE or DCE-DCE. Such cases need crossover cables, such as for the Ethernet or null modem for RS-232.[1]
D-sub connectors follow another rule for pin assignment.
- 25 pin DTE devices transmit on pin 2 and receive on pin 3.
- 25 pin DCE devices transmit on pin 3 and receive on pin 2.
- 9 pin DTE devices transmit on pin 3 and receive on pin 2.
- 9 pin DCE devices transmit on pin 2 and receive on pin 3.
Networking
A general rule is that DCE devices provide the clock signal (internal clocking) and the DTE device synchronizes on the provided clock (external clocking).
This term is also generally used in the Telco and Cisco equipment context to designate a network device, such as terminals, personal computers but also routers and bridges, that's unable or configured not to generate clock signals. Hence a direct PC to PC Ethernet connection can also be called a DTE to DTE communication. This communication is done via an Ethernet crossover cable as opposed to a PC to DCE (hub, switch, or bridge) communication which is done via an Ethernet straight cable.
V.35 is a high-speed serial interface designed to support both higher data rates and connectivity between DTEs (data-terminal equipment) or DCEs (data-communication equipment) over digital lines.
See also
References
- ^ EIA standard RS-232-C: Interface between Data Terminal Equipment and Data Communication Equipment Employing Serial Binary Data Interchange. Washington: Electronic Industries Association. Engineering Dept. 1969. OCLC 8250964307.