Jump to content

Salmson 2

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by NiD.29 (talk | contribs) at 20:10, 26 December 2020 (ditto). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Salmson 2 A.2
Role Reconnaissance biplane
Manufacturer Salmson
First flight Template:Avyear
Number built 3,800+

The Salmson 2 A.2, (often shortened to Salmson 2) was a French biplane reconnaissance aircraft developed and produced by Salmson to a 1916 requirement. Along with the Breguet 14, it was the main reconnaissance aircraft of the French army in 1918 and was also used by American Expeditionary Force aviation units. At the end of the First World War, one-third of French reconnaissance aircraft were Salmson 2s.

Design and development

During the First World War, the Salmson factory built aircraft engines, generally 9- and later 18-cylinder water-cooled radial engines developed from the Swiss Canton-Unné design, an early stationary radial engine design used for military aircraft. The company's first aircraft was the Salmson-Moineau S.M.1, an unusual three-seat reconnaissance biplane with twin propellers gear-driven from a single Salmson engine mounted sideways in the fuselage but it was not successful although it saw limited production.

The Salmson 2 came from a requirement to replace the Sopwith 1½ Strutter and Dorand A.R. reconnaissance aircraft in the A.2 (tactical reconnaissance) role. Salmson had built the 1½ Strutter under license, and the Salmson 2, while an original design, had more in common with the Sopwith than to the Salmson-Moineau. The aircraft was of conventional construction with a two-bay biplane configuration, powered by the company's own 230 hp (170 kW) Salmson 9Z water-cooled radial engine. Some minor control problems were quickly resolved in early testing, but the main defect of the Salmson 2, shared with the contemporary Airco DH.4, was that the pilot and gunner were widely separated, making communication difficult. Production was ordered after trials on 29 April 1917, and deliveries were underway by October of that year. Around 3,200 Salmson 2s were built in France, 2,200 by Salmson and the remainder by the Latécoère, Hanriot, and Desfontaines, companies. Some of these were Salmson 2 E.2 dual control advanced training (Ecole) aircraft.

Salmson 2 Limousine photo from L'Aéronautique October 1921
Salmson 2 Berline of Lignes Aeriennes Latécoére, circa 1918

Variants

Developments of the Salmson 2 included:

  • Salmson 2 A.2 standard model.
  • Salmson 2 E.2 dual control advanced training aircraft.
  • Salmson 4 Ab.2 was an enlarged version fitted with armour to meet the ground attack role. Production in 1918 was limited, and was cancelled at the end of the war.
  • Salmson 5 A.2 was a modified Salmson 2, with no production.
  • Salmson 7 A.2 was a modified Salmson 2. The primary change was that the pilot and gunner were seated back-to-back in a single cockpit. Large scale production was planned, but was cancelled with the end of the war.
  • Salmson Limousine ex-military Salmson 2s converted into enclosed civilian passenger aircraft after the First World War.
  • Salmson 2 Berline ex-military Salmson 2s converted into open cockpit civilian passenger aircraft after the First World War.
  • Kawasaki Army Otsu-1 (乙-1) Reconnaissance Aircraft was a Japanese licence-built Salmson 2 A.2.

Operational history

In addition to its service with the French army, the Salmson 2 served during the First World War with United States air units. Some 700 were purchased, and were generally successful.

Postwar Salmson 2s were purchased by Czechoslovakia, and remained in service until 1924. Others were transferred to Poland, but were withdrawn by 1920, and replaced by Bristol F.2Bs. Japan undertook licensed production as the Army Type Otsu 1, also known as the Kawasaki-Salmson. The number of aircraft built in Japan is unclear; 300 were built by Kawasaki, and the same quantity by the Imperial Japanese Army's Tokorozawa supply depot, although the total number of aircraft produced may have been as high as 1,000.

Military operators

Wartime

 France
 United States

Post-war

Japanese Otsu-1
 Belgium
 Czechoslovakia
 Japan
 Peru
 Poland
 Spain
 Russia /  Soviet Union
Replica Salmson 2 A.2/Otsu 1 in Japan

Survivors

  • Kakamigahara Aerospace Museum, Kakamigahara, Gifu (replica)
  • L'Envol des Pionniers, Toulouse, France (replica)

Specifications

Salmson 2 A.2 drawing

Data from French Aircraft of the First World War[1]

General characteristics

  • Crew: 2
  • Length: 8.5 m (27 ft 11 in)
  • Wingspan: 11.75 m (38 ft 7 in)
  • Height: 2.9 m (9 ft 6 in)
  • Wing area: 37.27 m2 (401.2 sq ft)
  • Empty weight: 780 kg (1,720 lb)
  • Gross weight: 1,290 kg (2,844 lb)
  • Powerplant: 1 × Salmson 9Za 9-cylinder water-cooled radial piston engine, 172 kW (231 hp)
  • Propellers: 2-bladed fixed-pitch propeller

Performance

  • Maximum speed: 188 km/h (117 mph, 102 kn) at sea level
  • Range: 500 km (310 mi, 270 nmi)
  • Service ceiling: 6,250 m (20,510 ft)
  • Time to altitude: 2,000 m (6,562 ft) in 7 minutes 13 seconds[2]

Armament

References

Wikimedia Commons has media related to Salmson 2.
  1. ^ Davilla, Dr. James J.; Soltan, Arthur (1997). French Aircraft of the First World War. Mountain View California: Flying Machines Press. pp. 25–26. ISBN 978-0-9637110-4-5.
  2. ^ Owers, Colin A.; Jon S. Guttman; James J. Davilla (2001). Salmson aircraft of World War I. Boulder, Colorado. pp. 26. ISBN 1 891268 16 3.{{cite book}}: CS1 maint: location missing publisher (link)

Further reading

Retrieved from "https://en.wikipedia.org/w/index.php?title=Salmson_2&oldid=996469304"