Search results

hose so that the nozzle and hose will detach and fuel flow stop if a motorist drives off with the nozzle still in the filler. Nozzles are usually color-coded...

shielding gas envelope. The plasma is then forced through a fine-bore copper nozzle which constricts the arc and the plasma exits the orifice at high velocities...

atmospheric contamination by an inert shielding gas (argon or helium). A filler metal is normally used, though some welds, known as 'autogenous welds',...

with decreasing nozzle diameter and increasing ink deposition speed, as these factors increase the effective shearing experienced by fillers suspended within...

the limitations of pressure, the attachment of the hose to the gooseneck nozzle allowed closer approaches and more accurate water application. Van der Heyden...

linking nozzle and an appropriate sausage casing brake. The movement of the linking nozzle is achieved by a drive integrated into the vacuum filler. The...

the nozzle must pass during refueling, preventing vapors from escaping alongside the nozzle. A liquid seal is created by the design of the filler pipe...

process. The process uses a welding head that has a nozzle for hot air and an extruder that pushes filler material out. The process entails heating the joining...

small one on the bottom and a larger one on the top called the inflation nozzle. The rings stop the tube from dropping through the stand or rising too far...

The molten pool is generally supplied with additional metal called filler. Filler material selection depends upon the metals to be welded. In oxy-fuel...

The gas nozzle directs the shielding gas evenly into the welding zone. Inconsistent flow may not adequately protect the weld area. Larger nozzles provide...

pumps have a large nozzle with a diameter of 15⁄16 inch (23.8 mm) which does not fit the 13⁄16-inch (20.6 mm) filler, and the nozzles are protected by a...

plug is replaced by a fuse, and the protector cap over the rocket-motor nozzle is removed; the 155 mm M549/M549A1 HERA is not intended to be fired in the...

at the same time, due to the force with which it is ejected from the nozzle. It can be sprayed onto any type or shape of surface, including vertical...

adhesives and fillers there are also the corresponding accessories such as a wide range of colorants, cartridge (applicator) gun, mixing nozzles etc. Above...

"Hoover nozzle", used on refueling equipment dispensing jet fuel, is designed with a flattened bell shape. It cannot be inserted in the filler neck of...

material or mixtures of thermoplastic binder with powder fillers. The material is pushed towards the nozzle by the action of a piston or a rotating screw, which...

Silicone rubbers are often one- or two-part polymers, and may contain fillers to improve properties or reduce cost. Silicone rubber is generally non-reactive...

simple. From the latter, it copied the enhanced warhead and the divergent nozzle at the launcher's rear to deflect recoil generated by launching the rocket...

variant's SDLF with a fuel tank and the aft swivel nozzle with a two-dimensional thrust vectoring nozzle for the CTOL variant. STOVL operation is made possible...