Bump stock

Bump firing is the act of using the recoil of a semi-automatic firearm to fire shots in rapid succession, which simulates the feeling of a fully automatic firearm. This process involves bracing the rifle with the non-trigger hand, releasing the grip on the firing hand (leaving the trigger finger in its normal position in front of the trigger), pushing the rifle forward in order to apply pressure on the trigger from the finger, and keeping the trigger finger stationary. During a shot, the firearm will recoil ("bump" back) and the trigger will reset as it normally does; then the non-trigger hand pulls the firearm away from the body and back to the original position, pressing the trigger against the stationary finger again, thereby firing another round when the trigger is pushed back.

This technique is usually used for entertainment, as the drawback of decreased accuracy eliminates any conceivable "tactical" advantage that might be gained. However when used in close proximity, the desired effect of many bullets hitting a target can easily be attained. Normally, a rifle is held securely and firmly against the shoulder but the loose shoulder hold that creates the rattle to rapidly depress the trigger affects accuracy that is not encountered with firearms that are designed for select-fire.

A similar method can be employed with semi-automatic pistols, in which one hand holds the grip, two fingers are placed in the trigger well, and then the grip hand shoves the weapon forwards while the trigger fingers remain stationary. With revolvers, rapid fire can be achieved by using two trigger fingers firing offset.

All these techniques greatly degrade the accuracy of the firearm, due to the necessary jerking of the weapon, which makes viable aiming impossible. The techniques trade accurate, aimed fire for an increase in the firearm's rate of fire. With bump-firing it is common to "empty the mag" with but it becomes easy to create a stoppage as the cycling of all semiautomatic firearms requires the bolt to move against the stationary firearm (low-mass semiautomatic pistols suffer from the same problem due to "limp wristing". The bolt must complete the stroke against the spring and that doesn't happen if both the bolt and spring are moving rearward. Non-bump fire rifles can suffer the same failure from fouling or for undercharged ammunition. Blanks also can cause these failures. The inaccuracy render the practice uncommon. None of these techniques fire more than one round with a single trigger pull, rather they compensate for biomechanical limitations associated with how fast a finger can repetitively pull the trigger. Paintball guns often have a two-finger long trigger that can be operated as a "trill" used on musical instruments. At least one company has adapted this to a rifle so alternating index and middle-finger trigger pulls increase the rate of fire.

Devices (from complicated, specially made triggers to the low-tech rubber band) may be employed in order to aid in the "bumping". However, not all such devices or modifications are legal. A famous example in the United States of America is the case of the Akins Accelerator for the Ruger 10/22. Though the Bureau of Alcohol, Tobacco, Firearms and Explosives (ATF) initially approved the device, they later reversed this ruling in 2005, two years after they had approved it for sale. This reversal was made due to a difference in the device submitted for approval and the device issued for sale. An additional spring was added after approval which caused the withdrawal. It has since been returned to market.