Jump to content

Datapoint 3300

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Pkunk (talk | contribs) at 12:54, 2 March 2014 (Datapoint 2200). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

The DataPoint 3300 was the first computer terminal manufactured by the Computer Terminal Corporation (later renamed to Datapoint Corporation), announced in 1967[1] and shipping in 1969.[2] Since this terminal was intended to replace a teleprinter such as those made by Teletype Corporation it was one of the first glass TTYs (glass for the screen, TTY as the abbreviation for "Teletype") ever produced.

As well as being sold under its own name, it was also sold as the DEC VT06 and the HP 2600A (introduced in 1972).[3]

Details

The Datapoint 3300 emulated a Teletype Model 33, but went beyond what a Teletype could achieve with its paper output. It supported control codes to move the cursor up, down, left and right, to the top left of the screen, or to the start of the bottom line. The 3300 could also clear to the end of the current line, or clear to the end of the screen.

It did not, however, support direct cursor positioning. It also had 25 rows of 72 columns of upper-case characters, rather than the 80 x 24 that would become more common in subsequent years.

Hardware

Unlike later terminals, such as the VT100, the Datapoint 3300 did not use a microprocessor in its implementation, but instead used TTL logic in small-scale integrated circuits.[4]

At the time of its introduction, RAM was expensive (it would not be until 1970 that Intel released the 1103, the first DRAM semiconductor memory chip making RAM affordable). Thus, the terminal stored its display of 25 rows of 72 columns of upper-case characters using fifty-four 200-bit shift registers, arranged in six tracks of nine packs each, providing storage for 1800 six-bit characters.[4] The shift-register design meant that scrolling the terminal display could be accomplished by simply pausing the display output to skip one line of characters.

References

See also