Jump to content

Emlenton Bridge

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Jseeherman (talk | contribs) at 04:29, 9 December 2015 (New Bridge in Nevada bumps Emlenton to fifth). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Emlenton Bridge
Coordinates41°10′27″N 79°41′51″W / 41.1743°N 79.6975°W / 41.1743; -79.6975
Carries I-80
CrossesAllegheny River
LocaleEmlenton, Pennsylvania
Maintained byPennsylvania Department of Transportation
Characteristics
DesignTruss bridge
MaterialSteel
Total length1,668 feet (508 m)
Width4 lanes
Longest span165 m
Clearance below270 feet (82 m)
History
Opened1968
Location
Map

The Emlenton Bridge is a steel deck truss bridge that spans the Allegheny River just south of the town of Emlenton, Pennsylvania at approximately mile marker 44.4 on I-80. With a height of 270 feet (82 m) above the river, the Emlenton Bridge was the highest bridge in the Interstate Highway System when completed in 1968 (The Lewiston-Queenston Bridge is higher but is technically an international bridge, not part of the Interstate Highway system). This record was held until 1971 with the opening of the Fred G. Redmon Bridge near Selah, Washington.

The Emlenton Bridge remains the highest road bridge in Pennsylvania; with an overall span of 1,668 feet (508 m) it was the largest bridge constructed as part of the Keystone Shortway project. With the completion of the Interstate System, it is likely that the Emlenton Bridge will remain the fifth highest bridge in the system for a significant time, behind the Glade Creek Bridge in West Virginia, the Pine Valley Creek Bridge in California, the Galena Creek Bridge in Nevada, and the aforementioned Redmon Bridge.

The bridge was designed by the consultant Buchart-Horn led by Ted Andrzejewski, an acquaintance of the noted bridge engineer Ralph Modjeski. The contractor of record is Brodhead Construction located in Aliquippa, Pennsylvania.[1]

An interesting fact about the Emlenton Bridge is that due to its size, and geography of the land, is actually located in three different Pennsylvania counties. One side of the bridge is in Venango County, the other in Clarion County, but the southwest abutment resides in Butler County.

See also

References

  1. ^ Shank, William (1990). Historic Bridges of Pennsylvania (Revised). York,PA: American Canal & Transportation Center. p. 65.