Explosive train
 |
A triggering sequence, also called an explosive train, is a sequence of events that culminates in the detonation of explosives. For safety reasons, most widely used high explosives are difficult to detonate. A primary explosive of higher sensitivity is used to trigger a uniform and predictable detonation of the main body of the explosive. Although the primary explosive itself is generally a more sensitive and expensive compound, it is only used in small quantities and in relatively safely packaged forms. By design there are low explosives and high explosives made such that the low explosives are highly sensitive (i.e. their 'Figure of Insensitivity' is low) and high explosives are comparatively insensitive. This not only affords inherent safety to the usage of explosives during handling and transport, but also necessitates an explosive triggering sequence or explosive train. The explosive triggering sequence or the explosive train essentially consists of an 'initiator', an 'intermediary' and the 'high explosive'.
For example, a match will not cause plastic explosive to explode, but it will light a fuse which will detonate a primary explosive that will shock a secondary high explosive and cause it to detonate. In this way, even very insensitive explosives may be used; the primary detonates a "booster" charge that then detonates the main charge. Triggering sequences are used in the mining industry for the detonation of ANFO and other cheap, bulk, and insensitive explosives that can not be fired by only a blasting cap or similar item.
Low Explosive Train
An example of a low-explosive train is a rifle cartridge, which consists of
- a primer consisting of a small amount of primary high explosive which initiates the explosive train
- an igniter which is initiated by the primer and creates a flame that ignites the propellant
- a propellant consisting of a secondary low explosive that emits a large amount of gas as it deflagrates.
High Explosive Train
High-explosives trains can be either two-step (e.g., detonator and dynamite) or three-step (e.g., detonator, booster of primary explosive, and main charge of secondary explosive).
Primary components
A high explosive train includes three primary high explosive components which are used to initiate explosives:
Detonators are often made from tetryl and fulminates.
Secondary components
In an explosive train there are two secondary high explosive components:
- Boosters
- Bursting charges, also known as main charges
Examples of bursting charges are
Tertiary components
In some cases, the main charge is so insensitive that using typical primary materials becomes impractical due to large amount required. Thus, an explosive booster is used to deliver sufficient shockwave to the main charge.
The most significant tertiary material in widespread use is ANFO.