Hot runner
A hot runner system is an assembly of heated components used in plastic injection molds that inject molten plastic into the cavities of the mold. (The cavities are the part of the mold shaped like the parts to be produced.) In hot runner mould generally used pinpoint gate.[1]
By contrast, a cold runner is simply a channel formed between the two halves of the mold, for the purpose of carrying plastic from the injection molding machine nozzle to the cavities. Each time the mold opens to eject the newly formed plastic parts, the material in the runner is ejected as well, resulting in waste. A hot runner system usually includes a heated manifold and a number of heated nozzles. The main task of the manifold is to distribute the plastic entering the mold to the various nozzles which then meter it precisely to the injection points in the cavities.[2]
Hot runner advantages
- Shorter cycle time: No runner controlling the cooling time
- Easier to start: Without runners to remove, and auto cycle occurs faster and more frequently
- Less sink marks and under-filled parts: Unlike when plastic flows through a cold runner and loses heat to mold plates
- Design flexibility: Can locate the gate at many points on the part
- Balanced melt flow: Separate melt channels are in externally heated manifolds that are insulated from mold plates surrounding them.[2]
Hot runner systems were first developed and came into sporadic use in the early 60s with generally negative results. They gained popularity in the 80s and 90s as technological allowed improved reliability and the escalation of plastic materials prices made hot runner systems more desirable and cost effective. Hot runners are fairly complicated systems, they have to maintain the plastic material within them heated uniformly, while the rest of the injection mold is being cooled in order to solidify the product quickly. For this reason they are usually assembled from components pre manufactured by specialized companies.
Two main types of hot runner systems are the externally heated and internally heated.[3] In the externally heated type, molten plastic runs within a solid manifold and within the nozzles. In the internally heated, (now obsolete) the plastic flows directly over slender heaters inside oversized runners. The outside boundaries of the runners normally solidify, so the plastic material flows only in proximity of the internal heaters or "torpedoes". A hot runner controller is a temperature controller used to control the temperature in the hot runner. This helps create the most consistent part(s).
Hot runners usually make the mold more expensive to manufacture and run, but allow savings by reducing plastic waste and by reducing the cycle time. (do not have to wait until the conventional runners freeze).
References
- ^ Products, K & B Molded. "Injection Molded Plastics - Custom Molding Services | K And B Molded". www.kandbmoldedproducts.com. Retrieved 2016-02-09.
- ^ a b "Seven Key Advantages of Hot Runner Systems | MoldMaking Technology". www.moldmakingtechnology.com. Retrieved 2016-02-09.
- ^ "Hot Runner Nozzles: Internally Heated Vs. Externally Heated | MoldMaking Technology". www.moldmakingtechnology.com. Retrieved 2016-02-09.