KarTrak

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 96.24.135.40 (talk) at 00:00, 9 March 2014. The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Detail of a KarTrak code.
A hopper with a KarTrak code mounted on its side

KarTrak, sometimes KarTrak ACI (for Automatic Car Identification) is a coloured bar code system designed to automatically identify rail cars and other rolling stock. KarTrak was made a requirement in North America, but technical problems led to abandonment of the system in the late 1970's.

History

In the late 1960s, railroads in North America began searching for a system that would allow them to automatically identify rail cars and other rolling stock. Through the efforts of the Association of American Railroads (AAR), a number of companies developed Automatic equipment identification (AEI) systems. The AAR selected four systems for extensive field tests. General Electric developed an RFID system, ABEX a microwave system, Wabco a black and white barcode system, and General Telephone and Electronics (GTE) a color barcode system called KarTrak. All those system, save for the RFID system, had labels that were mounted on each side of the rail car and a trackside scanner.

After the initial field tests, the ABEX, Wabco, and the GTE KarTrak ACI systems were selected for a head-to-head accuracy test on the Pennsylvania Railroad, at Spruce Creek PA. The KarTrak system was declared the winner and selected by the AAR as the standard.

Starting in 1968 all railcar owners were required by the AAR to install ACI labels on their cars. This requirement led to full-scale implementation of the ACI system in the early 1970s. By 1975 90% of all railcars were labeled. The read rate was about 80%, which means that after seven years of service 10% of the labels had failed for reasons such as physical damage and dirt accumulation. The dirt accumulation was most evident on flatcars that had low-mounted labels.

The AAR had recognized from their field tests that periodic inspection and label maintenance would be requirements to maintain a high level of label readability. Regulations were instituted for label inspection and repair whenever a railcar was in the repair shop, which on average happened every two years.

Unfortunately the maintenance program never gained sufficient compliance. Without maintenance the read rate failed to improve, and the KarTrak system was abandoned by the late 1970s. Because of this failure, the railroad industry did not seriously search for another system to identify rail cars until the mid-1980s.

Design

The different available KarTrak labels

KarTrak ACI tags consisted of a plate with 13 horizontal label, which could have 13 different forms. Next to the labels for numbers 0-9, three special labels existed; start and stop labels to mark the beginning and end of the code, and "10" as a check label.[1]

The labels each are 5 3/4" wide and 1" high, and have a 3/8" vertical gap between them. Labels could be affixed directly to the car side, but usually were applied to a dark plate which was then riveted to each side of the car.[2]

The labels are to be read from bottom to top, as such:

  • Line 1 (the lowermost) is always the start label.
  • Lines 2 to 5 are the equipment owner.
  • Lines 6 to 11 are the car number.
  • Line 12 is the always the stop label.
  • Line 13 is a check digit.

The first digit of the equipment owner (line 2) marks the type of equipment: 0 for railroad-owned, 1 for privately-owned or 6 for non-revenue equipment.

The car number is padded with zeroes if necessary. For locomotives, line 6 is the type of unit and line seven the suffix number.

The parity check digit is calculated as follows: Each number digit is multiplied by two to the power of [the labels's position minus two]. Thus the first digit (second line) is multiplied by 1, the second by 2, the third by 4, the fourth by 8 and so on, until the 10th which is multiplied by 512. The sum of all these numbers modulo 11 is the check digit.[1]

The code on the caboose in the picture at top can be decoded as Start 8350199918 Stop 5. This means a car with equipment code number 8, ownership code 350, which lists this as a car of the Illinois Central Gulf Railroad,[3] and car number 199918, with 5 as check digit.

Legacy

The KarTrak system proved to need too much maintenance to be practical. Up to 20% of the cars were not read correctly. This led to the abandonment of the system in the late 1970's.

Older cars can often still be seen with a KarTrak label.

KarTrak label decals are readily available for different model railroad scales.

References