Otter (fishing device)
The otter is a fishing device constructed with two parts, an otter board and a fishing line. It is steered by pulling on the line then letting stack so the slide mechanism on the board operates to switch direction. It may be used from a boat or pulled from the shore. It is very difficult to retrieve from a boat once fish are on. The board steers away from shore when the line is pulled and positioned by giving more or less line out. The board will travel parallel to the line of travel of the fisherman. It was introduced into Norway by British anglers sometime around the middle of the nineteenth century. The first account of such a device is found in connection with Irish sports fishermen in 1855.[1][2]
The otter may have multiple different designs. Otter boards used in bottom trawling are based on a similar design principle. The design takes advantage of the shearing effect achieved when the board is positioned at an oblique angle to the current. The effect is reminiscent of that of a kite in the wind.[2][1] Different designs are found in Switzerland, the Nordic countries, California and Japan. Most commonly, the traditional board was made of wood and had a length about 2 ft (0.61 m), a width of 6 in (15 cm), and a width of less than 1 in (2.5 cm). To enable it to float in an upright position, it was equipped with metal weights made of lead or iron.[3] The correct amount of weights allows the board to float with only 1–2 in (2.5–5.1 cm) above the surface. Snells, baited with flies or spoons are placed at intervals along the line. The snells would have different lengths due to the height above the water of the line along its length: 1 in (2.5 cm) adjacent to the board and hip-height adjacent to the fisherman.[3]
In Britain, fishing with an otter was forbidden by the Salmon Fishery Act 1861; this may have been one of the reasons why British anglers introduced it to Norway. The first ban on the device in Norway was imposed in 1870 and it was increasingly forbidden throughout the end of the century.[3]
References
[edit]- ^ a b M. Mukundan. "The design and construction of flat rectangular otter boards for bottom trawling - a review" (PDF). Retrieved 2021-05-18.
Otter door was used initially in the line fishing and is not an innovation of trawl fishery (Brandt, 1964; Davis, 1958). The name 'otter' derived from the board called as such and prevalently used in Ireland for the hook and line fishing
- ^ a b Andres von Brandt. Fish catching methods of the world. Farnham. pp. 76–78. ISBN 0852381255.
- ^ a b c Rugsveen, Magne (1986). Oteren (in Norwegian). pp. 317–339.