Jump to content

Pin mill

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Three-quarter-ten (talk | contribs) at 23:00, 13 January 2015 (Technically the wrong link target (wrong word sense)—fixed). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

A pin mill is a mill that comminutes materials by the action of pins that repeatedly move past each other. Much like a kitchen blender, it breaks up substances through repeated impact.

The mill is a type of vertical shaft impactor mill and consists of two rotating disks with pins embedded on one face. The disks are arrayed parallel to each other so that the pins of one disk face those of the other. The substance to be homogenized is fed into the space between the disks and either one or both disks are rotated at high speeds.

Pin mills can be used on both dry substances and liquid suspensions.[1]

Pin mills are commonly use in the manufacture of pharmaceuticals, as they can achieve particle sizes as low as a few micrometers.[1] However, heat generated by friction can sometimes be a concern.[2]

A manual form of the mill is commonly used to grind marijuana to a useful consistency.

References

  1. ^ a b Geōrgios D. Sarabakos; Athanasios E. Kosaropoulos (2002). Handbook of Food Processing Equipment. NY: Kluwer Academic / Plenum Publishing. p. 161. ISBN 0306472767.
  2. ^ Williams, Robert O. (2012). Formulating Poorly Water Soluble Drugs. Springer. pp. 147–150. ISBN 9781461411444.