|— Type —|
|Composition||Fe, Ni & Co (>95%), Ni (5%-25%)|
|TKW||~500 short tons (450 t)|
Widmanstätten pattern as seen on an etched and polished slice of the Seymchan meteorite. Scale unknown.
Iron meteorites are meteorites that consist overwhelmingly of an iron–nickel alloy known as meteoric iron that usually consists of two mineral phases, kamacite and taenite. Iron meteorites originate from planetary cores of planetesimals.
While they are fairly rare compared to the stony meteorites, comprising only about 5.7% of witnessed falls, iron meteorites have historically been heavily over-represented in meteorite collections. This is due to several factors:
- They are easily recognized as unusual even by laymen, as opposed to stony meteorites. Modern-day searches for meteorites in deserts and Antarctica yield a much more representative sample of meteorites overall.
- They are much more resistant to weathering.
- They are much more likely to survive atmospheric entry, and are more resistant to the resulting ablation. Hence they are more likely to be found as large pieces.
Since they are also denser than stony meteorites, iron meteorites also account for almost 90% of the mass of all known meteorites, about 500 tons. All the largest known meteorites are of this type, including the largest—the Hoba meteorite.
Iron meteorites have been linked to M-type asteroids since both types of objects have similar spectral characteristics in the visible and near-infrared wavelength regions. Iron meteorites are thought to be the fragments of the cores of larger ancient asteroids that have been shattered by impacts. The heat released from the radioactive decay of the short-lived nuclides 26Al and 60Fe is considered as a plausible cause for the melting and differentiation of their parent bodies in the early solar system. The IIE chemical class may be a notable exception, in that they probably originate from the crust of S-type asteroid 6 Hebe.
Chemical and isotope analysis indicates that at least about 50 distinct parent bodies were involved. This implies that there were once at least this many large, differentiated, asteroids in the asteroid belt – many more than today.
The overwhelming bulk of these meteorites consists of the Fe,Ni-alloys kamacite and taenite. Minor minerals, when occurring, often form rounded nodules of troilite or graphite, surrounded by schreibersite and cohenite. Schreibersite and troilite also occur as plate shaped inclusions, which show up on cut surfaces as cm-long and mm-thick lamellae. The troilite plates are called Reichenbach lamellae.
The chemical composition is dominated by the elements Fe, Ni and Co, which make up more than 95%. Ni is always present; the concentration is nearly always higher than 5% and may be as high as about 25%. A significant percentage of nickel can be used in the field to distinguish meteoritic irons from man-made iron products, which usually contain lower amounts of Ni, but it is not enough to prove meteoritic origin.
Iron meteorites were historically used for their meteoric iron which was forged into cultural objects, tools or weapons. With the advent of smelting and the beginning of the iron age the importance of iron meteorites as a resource decreased, at least in those cultures that developed those techniques. The Inuit used the Cape York meteorite for a much longer time. Iron meteorites themselves were sometimes used unaltered as collectibles or even religious symbols (e.g. Clackamas worshiping the Willamette meteorite). Today iron meteorites are prized collectibles for academic institutions and individuals. Some are also tourist attractions as in the case of the Hoba meteorite.
Two classifications are in use: the classic structural classification and the newer chemical classification.
The older structural classification is based on the presence or absence of the Widmanstätten pattern, which can be assessed from the appearance of polished cross-sections that have been etched with acid. This is connected with the relative abundance of nickel to iron. The categories are:
- Hexahedrites (H): low nickel, no Widmanstätten pattern, may present Neumann lines;
- Octahedrites (O): average to high nickel, Widmanstätten patterns, most common class. They can be further divided up on the basis of the width of the kamacite lamellae from coarsest to finest.
- Coarsest (Ogg): lamellae width > 3.3 mm
- Coarse (Og): lamellae width 1.3-3.3 mm
- Medium (Om): lamellae width 0.5-1.3 mm
- Fine (Of): lamellae width 0.2-0.5 mm
- Finest (Off): lamellae width < 0.2 mm
- Plessitic (Opl): a transitional structure between octahedrites and ataxites
- Ataxites (D): very high nickel, no Widmanstätten pattern, rare.
A newer chemical classification scheme based on the proportions of the trace elements Ga, Ge and Ir separates the iron meteorites into classes corresponding to distinct asteroid parent bodies. This classification is based on diagrams that plot nickel content against different trace elements (e.g. Ga, Ge and Ir). The different iron meteorite groups appear as data point clusters.
There were originally four of these groups designated by the roman numerals I, II, III, IV. When more chemical data became available these where split, e.g. Group IV was split into IVA and IVB meteorites. Even later some groups got joined again when intermediate meteorites were discovered, e.g. IIIA and IIIB were combined into the IIIAB meteorites.
In 2006 iron meteorites were classified into 13 groups (one for uncategorized irons):
- IIA: Hexahedrites, 5.3-5.7% Ni, 57-62 ppm Ga, 170-185 ppm Ge, 2-60ppm Ir.
- IIB: Coarsest octahedrites, 5.7-6.4% Ni, 446-59 pm Ga, 107-183 ppm Ge, 0.01-0.5 ppm Ir, Ge-Ni correlation negativ.
- IIC: Plessitic octahedrites, 9.3-11.5% Ni, 37-39 ppm Ga, 88-114 ppm Ge, 4-11 ppm Ir, Ge-Ni correlation positiv
- IID: Fine to medium octahedrites, 9.8-11.3%Ni, 70-83 ppm Ga, 82-98 ppm Ge, 3.5-18 ppm Ir, Ge-Ni correlation positiv
- IIE: octahedrites of various coarseness, 7.5-9.7% Ni, 21-28 ppm Ga, 60-75 ppm Ge, 1-8 ppm Ir, Ge-Ni correlation absent
- IIIAB: Medium octahedrites, 7.1-10.5% Ni, 16-23 ppm Ga, 27-47 ppm Ge, 0.01-19 ppm Ir
- IIICD: Ataxites to fine octahedrites, 10-23% Ni, 1.5-27 ppm Ga, 1.4-70 ppm Ge, 0.02-0.55 ppm Ir
- IIIE: Coarse octahedrites, 8.2-9.0% Ni, 17-19 ppm Ga, 3-37 ppm Ge, 0.05-6 ppm Ir, Ge-Ni correlation absent
- IIIF: Medium to coarse octahedrites, 6.8-7.8% Ni,6.3-7.2 ppm Ga, 0.7-1.1 ppm Ge, 1.3-7.9 ppm Ir, Ge-Ni correlation absent
- IVA: Fine octahedrites, 7.4-9.4% Ni, 1.6-2.4 ppm Ga, 0.09-0.14 ppm Ge, 0.4-4 ppm Ir, Ge-Ni correlation positiv
- IVB: Ataxites, 16-26% Ni, 0.17-0.27 ppm Ga, 0,03-0,07 ppm Ge, 13-38 ppm Ir, Ge-Ni correlation positiv
- Ungrouped meteorites. This is actually quite a large collection (about 15% of the total) of over 100 meteorites which do not fit into any of the larger classes above, and come from about 50 distinct parent bodies.
Additional groups and grouplets are discussed in the scientific literature:
Magmatic and primitive irons
The iron meteorites can be divided into two classes: magmatic irons and non magmatic or primitive irons.
|Primitive iron meteorites||IAB, IIE, Udei Station grouplet, Pitts grouplet, sLL, sLM, sLH, sHL, sHH|
|Magmatic iron meteorites||IC, IIAB, IIC, IID, IIF, IIG, IIIAB, IIIE, IIIF, IVA, IVB|
There are also specific categories for mixed-composition meteorites, in which iron and 'stony' materials are combined.
- II) Stony–iron meteorites
Meteorite fragment from the Cañon Diablo Meteorite 90mm wide
- Tamentit meteorite at Meteoritical Bulletin Database.
- M. K. Weisberg; T. J. McCoy, A. N. Krot (2006). "Systematics and Evaluation of Meteorite Classification". In D. S. Lauretta, H. Y. McSween, Jr. Meteorites and the early solar system II. Tucson: University of Arizona Press. pp. 19–52. ISBN 978-0816525621. Retrieved 15 December 2012.
- Emiliani, Cesare (1992). "Meteorites". Planet earth: cosmology, geology, and the evolution of life and environment. Cambridge University Press. p. 152. ISBN 978-0-521-40949-0.
- The Universal Book of Astronomy: From the Andromeda Galaxy to the Zone of Avoidance by David Darling (2003), p. 260.
- Sahijpal, S.; Soni, P.;Gagan, G. (2007). "Numerical simulations of the differentiation of accreting planetesimals with 26Al and 60Fe as the heat sources". Meteoritics & Planetary Science 42 (9): 1529–1548. Bibcode:2007M&PS...42.1529S. doi:10.1111/j.1945-5100.2007.tb00589.x.
- Gupta, G.; Sahijpal, S. (2010). "Differentiation of Vesta and the parent bodies of other achondrites". J. Geophys. Res. (Planets) 115 (E8). Bibcode:2010JGRE..11508001G. doi:10.1029/2009JE003525.
- J. G. Burke, Cosmic Debris: Meteorites in History. University of California Press, 1986.
- J. T. Wasson, Meteorites: Classification and Properties. Springer-Verlag, 1974.
- "Meteorites in History and Religion". Retrieved 13 December 2012.
- Vagn F. Buchwald, Handbook of Iron Meteorites. University of California Press, 1975.
- James H. Shirley,Rhodes Whitmore Fairbridge, Encyclopedia of planetary sciences, Springer, 1997. ISBN 978-0-412-06951-2
- Geochimica et cosmochimica acta, Volume 45, Ed. 9-12
- John T. Wasson: Meteorites. Springer-Verlag 1974.
- Scott, Edward R. D.; Wasson, John T. (1 January 1975). "Classification and properties of iron meteorites". Reviews of Geophysics 13 (4): 527. Bibcode:1975RvGSP..13..527S. doi:10.1029/RG013i004p00527.
- McSween, Harry Y. (1999). Meteorites and their parent planets (Sec. Ed. ed.). Cambridge: Cambridge Univ. Press. ISBN 978-0521587518.
- Wasson, John T.; Choe, Won-Hie (31 July 2009). "The IIG iron meteorites: Probable formation in the IIAB core". Geochimica et Cosmochimica Acta 73 (16): 4879–4890. Bibcode:2009GeCoA..73.4879W. doi:10.1016/j.gca.2009.05.062.
- Chinga meteorite at Meteoritical Bulletin Database.
|Wikimedia Commons has media related to Iron meteorites.|
- Meteorite articles, including discussions of iron meteorites, in Planetary Science Research Discoveries
- Iron Meteorite images from Meteorites Australia