A synchrotron is a particular type of cyclic particle accelerator originating from the cyclotron in which the guiding magnetic field (bending the particles into a closed path) is time-dependent, being synchronized to a particle beam of increasing kinetic energy (see image). The synchrotron is one of the first accelerator concepts to enable the construction of large-scale facilities, since bending, beam focusing and acceleration can be separated into different components.
Edwin McMillan constructed the first electron synchrotron in 1945, although Vladimir Veksler had already (unknown to McMillan) published the principle in a Soviet journal in 1944. The first proton synchrotron was designed by Sir Marcus Oliphant and built in 1952.
A storage ring is a special type of synchrotron in which the kinetic energy of the particles is kept constant.
A synchrotron light source is a combination of different electron accelerator types, including a storage ring in which the desired electromagnetic radiation is generated. This radiation is then used in experimental stations located on different beamlines. In addition to the storage ring, a synchrotron light source usually contains a linear accelerator (linac) and another synchrotron which is sometimes called booster in this context. The linac and the booster are used to successively accelerate the electrons to their final energy before they are magnetically "kicked" into the storage ring. Synchrotron light sources in their entirety are sometimes called "synchrotrons", although this is technically incorrect.
A cyclic collider is also a combination of different accelerator types, including two intersecting storage rings and the respective pre-accelerators.
Principle of operation
While a classical cyclotron uses both a constant guiding magnetic field and a constant-frequency electromagnetic field (and is working in classical approximation), its successor, the isochronous cyclotron, works by local variations of the guiding magnetic field, adapting the increasing relativistic mass of particles during acceleration.
In a synchrotron, this adaptation is done by variation of the magnetic field strength in time, rather than in space. For particles that are not close to the speed of light, the frequency of the applied electromagnetic field may also change to follow their non-constant circulation time. By increasing these parameters accordingly as the particles gain energy, their circulation path can be held constant as they are accelerated. This allows the vacuum chamber for the particles to be a large thin torus, rather than a disk as in previous, compact accelerator designs. Also, the thin profile of the vacuum chamber allowed for a more efficient use of magnetic fields than in a cyclotron, enabling the cost-effective construction of larger synchrotrons.
While the first synchrotrons and storage rings like the Cosmotron and ADA strictly used the toroid shape, the strong focusing principle independently discovered by Ernest Courant et al. and Nicholas Christofilos allowed the complete separation of the accelerator into components with specialized functions along the particle path, shaping the path into a round-cornered polygon. Some important components are given by radio frequency cavities for direct acceleration, dipole magnets (bending magnets) for deflection of particles (to close the path), and quadrupole / sextupole magnets for beam focusing.
The combination of time-dependent guiding magnetic fields and the strong focusing principle enabled the design and operation of modern large-scale accelerator facilities like colliders and synchrotron light sources. The straight sections along the closed path in such facilities are not only required for radio frequency cavities, but also for particle detectors (in colliders) and photon generation devices such as wigglers and undulators (in third generation synchrotron light sources).
The maximum energy that a cyclic accelerator can impart is typically limited by the maximum strength of the magnetic fields and the minimum radius (maximum curvature) of the particle path. Thus one method for increasing the energy limit is to use superconducting magnets, these not being limited by magnetic saturation. electron/positron accelerators may also be limited by the emission of synchrotron radiation, resulting in a partial loss of the particle beam's kinetic energy. The limiting beam energy is reached when the energy lost to the lateral acceleration required to maintain the beam path in a circle equals the energy added each cycle.
More powerful accelerators are built by using large radius paths and by using more numerous and more powerful microwave cavities. Lighter particles (such as electrons) lose a larger fraction of their energy when deflected. Practically speaking, the energy of electron/positron accelerators is limited by this radiation loss, while this does not play a significant role in the dynamics of proton or ion accelerators. The energy of such accelerators is limited strictly by the strength of magnets and by the cost.
Unlike in a cyclotron, synchrotrons are unable to accelerate particles from zero kinetic energy; one of the obvious reasons for this is that its closed particle path would be cut by a device that emits particles. Thus, schemes were developed to inject pre-accelerated particle beams into a synchrotron. The pre-acceleration can be realized by a chain of other accelerator structures like a linac, a microtron or another synchrotron; all of these in turn need to be fed by a particle source comprising a simple high voltage power supply, typically a Cockcroft-Walton generator.
Starting from an appropriate initial value determined by the injection energy, the field strength of the dipole magnets is then increased. If the high energy particle are emitted at the end of the acceleration procedure, e.g. to a target or to another accelerator, the field strength is again decreased to injection level, starting a new injection cycle. Depending on the method of magnet control used, the time interval for one cycle can vary substantially between different installations.
In large-scale facilities
One of the early large synchrotrons, now retired, is the Bevatron, constructed in 1950 at the Lawrence Berkeley Laboratory. The name of this proton accelerator comes from its power, in the range of 6.3 GeV (then called BeV for billion electron volts; the name predates the adoption of the SI prefix giga-). A number of transuranium elements, unseen in the natural world, were first created with this machine. This site is also the location of one of the first large bubble chambers used to examine the results of the atomic collisions produced here.
As part of colliders
Until August 2008, the highest energy collider in the world was the Tevatron, at the Fermi National Accelerator Laboratory, in the United States. It accelerated protons and antiprotons to slightly less than 1 TeV of kinetic energy and collided them together. The Large Hadron Collider (LHC), which has been built at the European Laboratory for High Energy Physics (CERN), has roughly seven times this energy (so proton-proton collisions occur at roughly 14 TeV). It is housed in the 27 km tunnel which formerly housed the Large Electron Positron (LEP) collider, so it will maintain the claim as the largest scientific device ever built. The LHC will also accelerate heavy ions (such as lead) up to an energy of 1.15 PeV.
The largest device of this type seriously proposed was the Superconducting Super Collider (SSC), which was to be built in the United States. This design, like others, used superconducting magnets which allow more intense magnetic fields to be created without the limitations of core saturation. While construction was begun, the project was cancelled in 1994, citing excessive budget overruns — this was due to naïve cost estimation and economic management issues rather than any basic engineering flaws. It can also be argued that the end of the Cold War resulted in a change of scientific funding priorities that contributed to its ultimate cancellation. However, the tunnel built for its placement still remains, although empty. While there is still potential for yet more powerful proton and heavy particle cyclic accelerators, it appears that the next step up in electron beam energy must avoid losses due to synchrotron radiation. This will require a return to the linear accelerator, but with devices significantly longer than those currently in use. There is at present a major effort to design and build the International Linear Collider (ILC), which will consist of two opposing linear accelerators, one for electrons and one for positrons. These will collide at a total center of mass energy of 0.5 TeV.
As part of synchrotron light sources
Synchrotron radiation also has a wide range of applications (see synchrotron light) and many 2nd and 3rd generation synchrotrons have been built especially to harness it. The largest of those 3rd generation synchrotron light sources are the European Synchrotron Radiation Facility (ESRF) in Grenoble, France, the Advanced Photon Source (APS) near Chicago, USA, and SPring-8 in Japan, accelerating electrons up to 6, 7 and 8 GeV, respectively.
Synchrotrons which are useful for cutting edge research are large machines, costing tens or hundreds of millions of dollars to construct, and each beamline (there may be 20 to 50 at a large synchrotron) costs another two or three million dollars on average. These installations are mostly built by the science funding agencies of governments of developed countries, or by collaborations between several countries in a region, and operated as infrastructure facilities available to scientists from universities and research organisations throughout the country, region, or world. More compact models, however, have been developed, such as the Compact Light Source.
- Life sciences: protein and large-molecule crystallography
- LIGA based microfabrication
- Drug discovery and research
- "Burning" computer chip designs into metal wafers
- Analysing chemicals to determine their composition
- Observing the reaction of living cells to drugs
- Inorganic material crystallography and microanalysis
- Fluorescence studies
- Semiconductor material analysis and structural studies
- Geological material analysis
- Medical imaging
- Particle therapy to treat some forms of cancer
- List of synchrotron radiation facilities
- Synchrotron X-ray tomographic microscopy
- Energy amplifier
- Superconducting Radio Frequency
- Zimmermann, F.; Mess, eds. (2013). Handbook of Accelerator Physics and Engineering (2nd ed.). World Scientific. ISBN 978-981-4417-17-4.
- J. David Jackson and W.K.H. Panofsky (1996). "EDWIN MATTISON MCMILLAN: A Biographical Memoir". National Academy of Sciences. Retrieved 2012-01-15.
- Wilson. "Fifty Years of Synchrotrons". CERN. Retrieved 2012-01-15.
- Veksler, V. I. (1944). "A new method of accelerating relativistic particles". Comptes Rendus (Doklady) de l’Academie Sciences de l’URSS 43 (8): 329–331.
- Nature 407, 468 (28 September 2000).
- Rotblat, Joseph (2000-09-28). "Obituary: Mark Oliphant (1901–2000)". Nature. Retrieved 2012-01-15.
- Courant, E. D.; Livingston, M. S.; Snyder, H. S. (1952). "The Strong-Focusing Synchrotron—A New High Energy Accelerator". Physical Review 88 (5): 1190–1196. Bibcode:1952PhRv...88.1190C. doi:10.1103/PhysRev.88.1190.
- Blewett, J. P. (1952). "Radial Focusing in the Linear Accelerator". Physical Review 88 (5): 1197–1199. Bibcode:1952PhRv...88.1197B. doi:10.1103/PhysRev.88.1197.
- US patent 2736799, Nicholas Christofilos, "Focussing System for Ions and Electrons", issued 1956-02-28
- The Cosmotron
|Wikimedia Commons has media related to Synchrotrons.|
- Elettra Sincrotrone Trieste - Elettra and Fermi lightsources
- Canadian Light Source
- Australian Synchrotron
- French synchrotron Soleil
- Diamond UK Synchrotron
- CERN Large Hadron Collider
- Synchrotron Light Sources of the World
- A Miniature Synchrotron: room-size synchrotron offers scientists a new way to perform high-quality x-ray experiments in their own labs, Technology Review, February 4, 2008
- Brazilian Synchrotron Light Laboratory
- Podcast interview with a scientist at the European Synchrotron Radiation Facility
- Indian SRS
- Sameen Ahmed Khan, Synchrotron Radiation (in Asia), ATIP Report, No. ATIP02.034, 28 pages (21 August 2002). (ATIP: The Asian Technology Information Program, Tokyo, Japan, 2002). Complete Report.
- Spanish ALBA Light Source