Flip clock: Difference between revisions

From Wikipedia, the free encyclopedia
Content deleted Content added
Line 14: Line 14:
== Daylight Saving Time ==
== Daylight Saving Time ==
[[Image:Clock radio.png|thumb|300px|right|A 1969 radio alarm clock (Sony Digimatic 8FC-59W) with an early digital display]]
[[Image:Clock radio.png|thumb|300px|right|A 1969 radio alarm clock (Sony Digimatic 8FC-59W) with an early digital display]]
Analog clocks with digital displays cannot be wound back, as the flip mechanism operates only in one direction. Instead they must be wound forward 23 hours to achieve the effect of winding back 1 hour at the end of [[daylight saving time]]. Or by stopping it for an hour.
Analog clocks with digital displays cannot be wound back, as the flip mechanism operates only in one direction. Instead they must be wound forward 23 hours to achieve the effect of winding back 1 hour at the end of [[daylight saving time]], or by stopping it for an hour.


== See also ==
== See also ==

Revision as of 18:58, 3 November 2007

Diagram of the "flip" mechanism in an analog-digital clock.

An analog clock with digital display is a clock which displays information in a digital format, but actually keeps track of the time in an analog fashion. This type of clock is commonly referred to as a "flip clock."

Method of operation

An electric motor turns two wheels continuously: the faster at a rate of 1 revolution per hour, the slower at a rate of 1 revolution per 24 hours. The wheels move continuously, not in steps.

The faster wheel has connected to it a ring of 60 flat plastic "leaves". On the "leaves" are printed numerals so that, when you hold two adjacent "leaves" apart like an open book, the two open "leaves" spell out a numeral, and flipping a "leaf" increases the number shown by 1 unit. The "book" is opened vertically, and its pages form a ring. This ring is put into position and rotated so that one page falls each minute, showing a new number for the minutes. "Leaves" 45 through 59 have a small tooth on them. The purpose of this tooth is explained later.

The slower wheel has connected to it a similar ring of "leaves", but there are only 48 "leaves" on this ring. These "leaves" have hour numbers printed on them. There are two of each hour, like this: 12am, 12am, 1am, 1am, 2am, 2am, ... 11pm, 11pm. One leaf falls each half-hour, at approximately 25 and 55 minutes after the hour.

It has been mentioned that the hours do not fall in sync with the minutes. The presence of teeth on the minute leaves has also been mentioned. These teeth are used as follows: At 45 minutes after the hour, the tooth pushes a lever which will catch any falling hour leaf. The lever holds the old hour leaf in place until it is time for the new hour to start.


Daylight Saving Time

A 1969 radio alarm clock (Sony Digimatic 8FC-59W) with an early digital display

Analog clocks with digital displays cannot be wound back, as the flip mechanism operates only in one direction. Instead they must be wound forward 23 hours to achieve the effect of winding back 1 hour at the end of daylight saving time, or by stopping it for an hour.

See also