OTRAG

For the rocket, see OTRAG (rocket).

OTRAG (Template:Lang-de, or Orbital Transport and Rockets, Inc.), was a German company based in Stuttgart, which planned in the late 1970s and early 1980s to develop an alternative propulsion system for rockets. OTRAG was the first commercial developer and producer of space launch vehicles. The OTRAG Rocket claimed to present an inexpensive alternative to existing launch systems through mass-production of Common Rocket Propulsion Units (CRPU).

History

OTRAG was founded in 1975 by the German aerospace engineer Lutz Kayser. Its goal was to develop, produce, and operate a radically different, low cost, satellite launch vehicle.

The OTRAG rocket was intended to be an inexpensive alternative to the European rocket Ariane and the NASA space shuttle. Kayser and a private consortium of six hundred European investors financed the development and production of the OTRAG satellite launch vehicle. Dr.Ing Kurt H. Debus served as Chairman of the Board of OTRAG after his retirement as director of NASA's Kennedy Space Center, and Dr. Wernher von Braun served as scientific adviser to Kayser.

In the face of doubts by Debus and von Braun, Kayser chose in 1975 to set up testing and launch facilities in Shaba, Zaire (now Katanga Province in the Democratic Republic of the Congo). Debus and von Braun were concerned about the possibility of Zairian acquisition of missile technology from the facilities. Kayser decided to proceed despite their opposition, and testing began at the site in 1977.

Political pressure to halt the company's operations mounted quickly. France and the Soviet Union were historically opposed to German long-distance rocket development, and pressured the Congolese government into closing down the development facility in 1979. Immediately afterwards, Presidents Giscard d'Estaing of France and Leonid Brezhnev of the Soviet Union convinced the West German government to cancel the OTRAG project and close down its German operations. In 1980, OTRAG moved its production and testing facilities to a desert site in Libya. A series of successful tests were conducted at this site beginning in 1981.

Rocket design

OTRAG was a design quite different from conventional multi-stage rockets. The OTRAG design used parallel stages assembled from parallel tanktubes with flat bulkheads. The rockets were designed to carry loads up to two tons, the then usual weight of a communications satellite, into a geostationary orbit. It was planned to later increase the capacity to ten tons or more using multiple identical modules.

The rocket was to consist of individual pipes, each 27 cm in diameter and six meters long. Four of these pipes would be installed one above the other resulting in a 24 meter long fuel and oxidizer tank with a rocket engine at the lower end. The fuel was intended to be kerosene with a 50/50 mixture of nitric acid and dinitrogen tetroxide as an oxidiser. Ignition was provided by a small quantity of furfuryl alcohol injected before the fuel, which ignites hypergolically (immediately and energetically) upon contact with the nitric acid. To simplify the design, pumps were not used to move the fuel to the engines, instead the fuel tanks were only 66% filled, with compressed air in the remaining space to press propellants into the ablatively cooled combustion chamber. Thrust control is by partially closing the electromechanical propellant valves. Pitch and yaw control can thus be achieved by differential throttling. In principle this is extremely reliable and cheap in mass production.

The modular design was intended to result in a large cost reduction due to economies of scale. The CRPU-based satellite launching rocket was estimated to cost approximately one tenth of conventional designs. Automated production processes for all components would reduce labor cost from 80% to 20% and remove the justification for reusability of spent stages.

Controversies and future outlook

Only a few political controversies are known concerning OTRAG because of concerns of neighbors of Zaire and Libya about the dual use potential of rockets. A full orbital launch vehicle was never assembled. Modules were flight tested in Zaire and Libya. 6,000 static rocket engine tests and 16 single-stage qualification tests were made to prove the concept as feasible .

The German minister of foreign affairs at that time, Hans Dietrich Genscher, is said to have finally stopped the project under pressure from France and the Soviet Union, and West Germany joined the co-financed "European rocket" Ariane project, which made the OTRAG project unnecessary and eliminated political entanglements of a still divided Germany in the early 1980s.

NASA Commercial Orbital Transportation Services announcement stipulates a 50% US National ownership in vendor companies like von Braun Debus Kayser Rocket Science LLC, DE (BDKRS). This would force Kayser, a German citizen, to sell at least 50% of his shares to Americans .

More recently, the company has been advising Interorbital Systems, resulting in a similar modular rocket design for their Neptune series.

John Carmack, founder and lead engineer of Armadillo Aerospace has stated in his monthly reports and in forum posts that he expects his path to an orbital vehicle to include modular rockets similar to OTRAG technology. Kayser, being the founding engineer of OTRAG, visited Armadillo in May, 2006 and loaned Carmack some of their original research hardware.

"I have been corresponding with Lutz [Kayser] for a few months now, and I have learned quite a few things. I seriously considered an OTRAG style massive-cluster-of-cheap-modules orbital design back when we had 98% peroxide (assumed to be a biprop with kerosene), and I have always considered it one of the viable routes to significant reduction in orbital launch costs. After really going over the trades and details with Lutz, I am quite convinced that this is the lowest development cost route to significant orbital capability. Eventually, reusable stages will take over, but I actually think that we can make it all the way to orbit on our current budget by following this path. The individual modules are less complicated than our current vehicles, and I am becoming more and more fond of high production methods over hand crafter prototypes." -- June 2006 Armadillo Aerospace Update

See also

• OTRAG Rocket
• Pressure-fed engine (rocket)

External links

• http://www.b14643.de/Spacerockets_1/West_Europe/OTRAG/Description/Frame.htm
• http://www.bernd-leitenberger.de/otrag.shtml very explantive article about the OTRAG history (de)
• http://www.astronautix.com/lvs/otrag.htm (en)