Jump to content

FR-2

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 103.21.175.72 (talk) at 20:17, 23 August 2023 (Further reading: good enough). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

FR-2 (Flame Resistant 2) is a NEMA designation for synthetic resin bonded paper, a composite material made of paper impregnated with a plasticized phenol formaldehyde resin, used in the manufacture of printed circuit boards. Its main properties are similar to NEMA grade XXXP (MIL-P-3115) material, and can be substituted for the latter in many applications.

Applications

FR-2 sheet with copper foil lamination on one or both sides is widely used to build low-end consumer electronic equipment. While its electrical and mechanical properties are inferior to those of epoxy-bonded fiberglass, FR-4, it is significantly cheaper. It is not suitable for devices installed in vehicles, as continuous vibration can make cracks propagate, causing hairline fractures in copper circuit traces. Without copper foil lamination, FR-2 is sometimes used for simple structural shapes and electrical insulation.

Properties

Property Value
Dielectric constant, or relative permittivity 4.5 @ 1 MHz
Dissipation factor 0.024–0.26 @ 1 MHz
Dielectric strength 29 kV/mm (740 V/thou)

Fabrication

FR-2 can be machined by drilling, sawing, milling and hot punching. Cold punching and shearing are not recommended, as they leave a ragged edge and tend to cause cracking. Tools made of high-speed steel can be used, although tungsten carbide tooling is preferred for high volume production.

Adequate ventilation or respiration protection are mandatory during high-speed machining, as it gives off toxic vapors.

Trade names and synonyms

  • Carta[1]
  • Haefelyt
  • Lamitex
  • Paxolin, Paxoline
  • Pertinax,[1] taken over by Lamitec[2] and Dr. Dietrich Müller GmbH in 2014[3]
  • Getinax (in the Ex-USSR)
  • Phenolic paper
  • Preßzell[1]
  • Repelit[1]
  • Synthetic resin bonded paper (SRBP)
  • Turbonit[1]
  • Veroboard
  • Wahnerit[1]

See also

References

  1. ^ a b c d e f g Mehdorn, Walter (1949). Kunstharzpreßstoffe und andere Kunststoffe - Eigenschaften, Verarbeitung, Anwendungen (PDF) (in German) (3 ed.). p. 240. doi:10.1007/978-3-662-12205-1. ISBN 978-3-662-12206-8. Archived (PDF) from the original on 2021-03-20. Retrieved 2021-03-20. (viii+355 pages)
  2. ^ "lamitec.de". Archived from the original on 2006-08-04. Retrieved 2006-08-05.
  3. ^ "Pertinax – ein traditionsreiches Material mit neuer Zukunft" (in German). Müller Ahlhorn. 2014-01-06. Archived from the original on 2020-12-03. Retrieved 2021-03-20.

Further reading