Dissociation constant
In chemistry and biochemistry, a dissociation constant is a specific type of equilibrium constant that measures the propensity of a larger object to separate (dissociate) reversibly into smaller components, as when a complex falls apart into its component molecules, or when a salt splits up into its component ions. The dissociation constant is usually denoted and is the inverse of the association constant. In the special case of salts, the dissociation constant can also be called an ionization constant.
For a general reaction
in which a complex breaks down into x A subunits and y B subunits, the dissociation constant is defined
where [A], [B], and [AxBy] are the concentrations of A, B, and the complex AxBy, respectively.
Protein-Ligand binding
The dissociation constant is commonly used to describe the affinity between a ligand () (such as a drug) and a protein () i.e. how tightly a ligand binds to a particular protein. Ligand-protein affinities are influenced by non-covalent intermolecular interactions between the two molecules such as hydrogen bonding, electrostatic interactions , hydrophobic and Van der Waals forces. They can also be affected by high concentrations of other macromolecules, which causes macromolecular crowding.[1][2]
The formation of a ligand-protein complex () can be described by a two-state process
the corresponding dissociation constant is defined
where [], [] and [] represent the concentrations of the protein, ligand and complex, respectively.
The dissociation constant has molar units (M), which correspond to the concentration of ligand [] at which the binding site on a particular protein is half occupied, i.e. the concentration of ligand, at which the concentration of protein with ligand bound [], equals the concentration of protein with no ligand bound []. The smaller the dissociation constant, the more tightly bound the ligand is, or the higher the affinity between ligand and protein. For example, a ligand with a nanomolar (nM) dissociation constant binds more tightly to a particular protein than a ligand with a micromolar (M) dissociation constant.
Sub-nanomolar dissociation constants as a result of non-covalent binding interactions between two molecules are rare. Nevertheless, there are some important exceptions. Biotin and avidin bind with a dissociation constant of roughly M = 1 fM = 0.000001 nM.[3] Ribonuclease inhibitor proteins may also bind to ribonuclease with a similar M affinity.[4] The dissociation constant for a particular ligand-protein interaction can change significantly with solution conditions (e.g. temperature, pH and salt concentration). The effect of different solution conditions is to effectively modify the strength of any intermolecular interactions holding a particular ligand-protein complex together.
Drugs can produce harmful side effects through interactions with proteins for which they were not meant to or designed to interact. Therefore much pharmaceutical research is aimed at designing drugs that bind to only their target proteins with high affinity (typically 0.1-10 nM) or at improving the affinity between a particular drug and its in-vivo protein target.
Another notation
A dissociation constant is sometimes expressed by its p, which is defined as:
These p's are mainly used for covalent dissociations (i.e., reactions in which chemical bonds are made or broken) since such dissociation constants can vary greatly.
Dissociation constant of water
As a frequently used special case, the dissociation constant of water is often expressed as Kw:
The concentration of water is not included in the definition of Kw, for reasons described in the article equilibrium constant.
The value of Kw varies with temperature, as shown in the table below. This variation must be taken into account when making precise measurements of quantities such as pH.
Water temperature | Kw*10-14 | pKw |
---|---|---|
0°C | 0.1 | 14.92 |
10°C | 0.3 | 14.52 |
18°C | 0.7 | 14.16 |
25°C | 1.2 | 13.92 |
30°C | 1.8 | 13.75 |
50°C | 8.0 | 13.10 |
60°C | 12.6 | 12.90 |
70°C | 21.2 | 12.67 |
80°C | 35 | 12.46 |
90°C | 53 | 12.28 |
100°C | 73 | 12.14 |
Acid base reactions
For the deprotonation of acids, K is known as Ka, the acid dissociation constant. Stronger acids, for example sulfuric or phosphoric acid, have larger dissociation constants; weaker acids, like acetic acid, have smaller dissociation constants. A molecule can have several acid dissociation constants. In this regard, that is depending on the number of the protons they can give up, we define monoprotic, diprotic and triprotic acids. The first (e.g. acetic acid or ammonium) have only one dissociable group, the second (carbonic acid, bicarbonate, glycine) have two dissociable groups and the third (e.g. phosphoric acid) have three dissociable groups. In the case of multiple pK values they are designated by indices: pK1, pK2, pK3 and so on. For amino acids, the pK1 constant refers to its carboxyl (-COOH) group, pK2 refers to its amino (-NH3) group and the pK3 is the pK value of its side chain.
References
- ^ Zhou HX, Rivas G, Minton AP (2008). "Macromolecular crowding and confinement: biochemical, biophysical, and potential physiological consequences". Annu Rev Biophys. 37: 375–97. doi:10.1146/annurev.biophys.37.032807.125817. PMID 18573087.
{{cite journal}}
: CS1 maint: multiple names: authors list (link) - ^ Minton AP (2001). "The influence of macromolecular crowding and macromolecular confinement on biochemical reactions in physiological media". J. Biol. Chem. 276 (14): 10577–80. doi:10.1074/jbc.R100005200. PMID 11279227.
{{cite journal}}
: CS1 maint: unflagged free DOI (link) - ^ Livnah O, Bayer EA.; et al. (1993). "Three-dimensional structures of avidin and the avidin-biotin complex". Proc Natl Acad Sci USA. 90 (11): 5076–5080. doi:10.1073/pnas.90.11.5076. PMID 8506353.
{{cite journal}}
: Explicit use of et al. in:|author=
(help) - ^ Johnson RJ, McCoy JG.; et al. (2007). "Inhibition of Human Pancreatic Ribonuclease by the Human Ribonuclease Inhibitor Protein". Journal of Molecular Biology. 368 (2): 434–449. doi:10.1016/j.jmb.2007.02.005. PMID 17350650.
{{cite journal}}
: Explicit use of et al. in:|author=
(help); Unknown parameter|month=
ignored (help)