Jump to content

TNC connector

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Citation bot (talk | contribs) at 12:51, 23 November 2021 (Alter: url. URLs might have been anonymized. Add: title. Changed bare reference to CS1/2. | Use this bot. Report bugs. | Suggested by BrownHairedGirl | Linked from User:BrownHairedGirl/Articles_with_bare_links | #UCB_webform_linked 1974/2179). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

TNC
TNC connector on the left beside BNC.
Type RF coaxial connector
Production history
Designer Paul Neill and Carl Concelman
Designed Late 1950s
Manufacturer Various
General specifications
Diameter Male: 0.590 in (15.0 mm)
Female: 0.378 in (9.6 mm)
(outer, typical)
Thread 7/16-28 UNEF
Cable Coaxial
Passband Typically 0–11 GHz

The TNC connector (acronym of "Threaded Neill–Concelman") is a threaded version of the BNC connector.

Description

The interface specifications for the TNC and many other connectors are referenced in MIL-STD-348.[1] The connector has a 50 Ω impedance and operates best in the 0–11 GHz frequency spectrum. It has better performance than the BNC connector at microwave frequencies. Invented in the late 1950s and named after Paul Neill of Bell Labs and Carl Concelman of Amphenol, the TNC connector has been employed in a wide range of radio and wired applications.[2][3]

The abbreviation TNC is sometimes given as standing for Threaded Navy Connector.[4][5]

The TNC connector features a 7/16"-28 thread.[6]

Variations

Reverse-polarity TNC

Left, a male RP-TNC connector from a 2.4GHz antenna. Right, a standard male TNC connector on a UHF antenna.

Reverse-polarity TNC (RP-TNC, sometimes RTNC) is a variation of the TNC specification which reverses the polarity of the interface. This is usually achieved by incorporating the female contacts normally found in jacks into the plug, and the male contacts normally found in plugs into the jack.[7]

Because they were not readily available, RP-TNC connectors have been widely used by Wi-Fi equipment manufacturers to comply with specific local regulations, such as those from the FCC,[8] which are designed to prevent consumers from connecting antennas which exhibit gain and therefore breach compliance. The FCC considered that the RP-TNC was acceptable in preventing consumers changing the antenna; but by 2000 it regarded them as readily available,[9] though delaying its ruling indefinitely.[10] As of 2013, leading manufacturers are still using RP-TNC connectors on their Wi-Fi equipment.[11] Plug on the female connector and receptacle on the male when dealing with RP-TNC.

75 ohm TNC

Most TNC connectors are 50-ohm type even when used with coaxial cable of other impedances,[citation needed] but a 75-ohm series is also available, providing a good SWR to about 1 GHz.[12] These can be recognized by a reduced amount of dielectric in the mating ends. They are intermatable with standard types.

See also

References

  1. ^ RADIO FREQUENCY CONNECTOR INTERFACES FOR MIL-DTL-3643, MIL-DTL-3650, MIL-DTL-3655, MIL-DTL-25516, MIL-PRF-31031, MIL-PRF-39012, MIL-PRF-49142, MIL-PRF-55339, MIL-DTL-83517 (B with change 3 ed.). US DOD. 2017-01-22.
  2. ^ E-Base Interactive. "TNC Connector Series". Amphenol RF. Retrieved 2011-01-12.
  3. ^ "Electronic Warfare and Radar Systems Engineering Handbook". Microwaves101.com. Naval Air Systems Command. April 1999. pp. 1.15, 6.32. Retrieved 16 January 2017.
  4. ^ Lange, K.; Locherer, K.-H., eds. (1986). Taschenbuch der Hochfrequenztechnik (4 ed.). Springer-Verlag. p. L10. ISBN 978-3-64296894-5. Retrieved 16 January 2017.
  5. ^ Das, Annapurna; Das, Sisir K. (2000). Microwave Engineering (2000 ed.). New Delhi: Tata McGraw-Hill Publishing Company Ltd. p. 154. ISBN 0-07-463577-8. Retrieved 16 January 2017.
  6. ^ "TNC Connectors | Wellshow -RF Connector, RF Coaxial Cable Assembly, GSM, GPS, WiFi Antenna Manufacturer".
  7. ^ "RP-TNC Connector".
  8. ^ U.S. Code of Federal Regulations: 47 CFR 15.203, available at http://www.ecfr.gov
  9. ^ FCC public notice, "OET clarifies antenna connector requirements for Part 15 Unlicensed Transmitters", http://hraunfoss.fcc.gov/edocs_public/attachmatch/DA-00-1087A1.pdf
  10. ^ FCC public notice, "OET extends effective data of antenna connector requirement indefinitely" http://hraunfoss.fcc.gov/edocs_public/attachmatch/DA-00-2225A1.pdf
  11. ^ Getting Started Guide: Cisco 3600 Series Access Points http://www.cisco.com/en/US/docs/wireless/access_point/3600/quick/guide/ap3600getstart.html#wp59090
  12. ^ "HUBER+SUHNER TNC 75 Ohm series (EN)". Hubersuhner.com. 2010-10-28. Archived from the original on 2011-07-12. Retrieved 2011-01-12.
Retrieved from "https://en.wikipedia.org/w/index.php?title=TNC_connector&oldid=1056771016"