Search results

below). In all snaplocks, the flint is held in a clamp at the end of a bent lever called the cock. When the gun is "cocked", the cock is held back, against...

side of the revolver). Kerr rammer, patented by James Kerr in 1855, a bent lever (bent downwards at a right or obtuse angle, with a short ramrod on the lower...

main charge (propellant). The flint is held in a clamp at the end of a bent lever called the cock. Upon pulling the trigger, this moves forward under the...

connected to the operating mechanism of the scoop. Water scoop arm A bent lever or bell crank, to one end of which the air cylinder piston rod is attached...

the lever, but instead of lever arms that are parallel to each other, one lever arm is bent at an angle such that the force exerted at the bent lever arm...

Lever House is a 307-foot-tall (94 m) office building at 390 Park Avenue in the Midtown Manhattan neighborhood of New York City. Constructed from 1950...

the stigma is bent down in a general location that corresponds to where the pollen was deposited on the pollinator's body. The lever of most Salvia species...

another lever that stood on the first tier, and the lever again used to lift it from this tier to the next. It may be that there was a new lever on each...

triceps, and deltoids, especially the anterior portion. Front lever and back lever A front lever is performed by executing a lateral pulldown of the bar with...

pose in yoga as exercise, the body supported on bent arms Plank (exercise) Gymnastics Front Lever Back lever Human flag "Top 10 planche variations". Calisthenics...

such a device ensures only the portion of the saw under the pin is bent. The lever type of saw set (also referred to as plate, wrest, spring or comb set)...

resistance to the person using the machine. Each of the simple machines (pulley, lever, wheel, incline) changes the mechanical advantage of the overall machine...

has a curved lever rather than the bent straight lever of the M213. The M57 is the M26A2 with a "jungle clip" safety attached to the lever. The L2 series...

Outwood, Radcliffe and Little Lever. In 1880 there were ten working pits listed for Little Lever: Bally, Harpurfold, Middle Bents and Stopes, owned by Thomas...

except that the M7 has a much larger muzzle ring. The M7 has the same two-lever locking mechanism as the M4, that connects to a lug on the M16 rifle's barrel...

constructed near the tracks through an elaborate system of rods and levers. The levers were also used to control railway signals to control the movement...

world and the Przeworsk and Chernyakhov cultures. Roman padlocks had a long bent rod attached to the case, and a shorter piece which could be inserted into...

removed. Multiple-levers: Having at least two spring loaded levers that are each operated with one hand. Magnetic: Have two small levers with embedded magnets...

gastrocnemius (a knee flexor), so the movement is done to emphasize the soleus. Bent-knee calf raises are frequently done in a seated position for comfort. Since...

leg. The bottom leg may be bent with the foot outside the opposite hip or extended with toes vertically. The arms help lever the torso into the twist,...