Search results

and in its four sequels—Shaft's Big Score!, Shaft in Africa, Shaft (2000) and Shaft (2019)—as well as in the seven 1973–74 Shaft television films. Samuel...

Ben and Shaft join forces to find Bumpy's daughter. Later, Shaft surmises that mobsters are watching his apartment from a local bar. Shaft pretends to...

Place" – 3:24 "Soulsville" (Vocal Version) – 3:48 "No Name Bar" – 6:11 "Bumpy's Blues" – 4:04 "Shaft Strikes Again" – 3:04 "Do Your Thing" (Vocal Version)...

I-shaped cross-section shaft. Versions using relatively wide flat steel bar are often referred to as "utility" or "flat bars". The accepted etymology...

"Theme from Shaft", written and recorded by Isaac Hayes in 1971, is the soul and funk-styled theme song to the Metro-Goldwyn-Mayer film Shaft. The theme...

R&B number 3) in 1967, "Son of Shaft" (R&B number 10) in 1972, and "Boogie Body Land" (R&B number 7) in 1980. The Bar-Kays began in Memphis, Tennessee...

attached implement or separate machine. Most commonly, it is a splined drive shaft installed on a tractor or truck allowing implements with mating fittings...

narrow passages, these complexes typically feature entrance shafts, rooms, halls, ventilation shafts, and various amenities such as locking mechanisms, lighting...

A cheater bar, snipe, or cheater pipe is an improvised breaker bar made from a length of pipe and a wrench (spanner). Cheater bars are usually used to...

some variations mimic large swizzle sticks, with a disc at one end. The shaft is typically thin and threaded so that the fingers can easily grip and rotate...

usually consist of an impeller and a shaft. An impeller is a rotor located within a tube or conduit attached to the shaft. It helps enhance the pressure in...

two separate species called the yellow-shafted flicker (C. auratus, with four subspecies) and the red-shafted flicker (C. cafer, with six subspecies,...

German), which typically consists of a wooden shaft joined by a length of chain to one or more iron-shod wooden bars. (Heavy sword pommels have also been used...

locked doors. One variant of the Halligan has a heavy sliding collar on the shaft. Once the prying end of the tool is wedged into position, the sliding "hammer"...

barbells. For example, they have a shaft diameter of 28.5 mm which is between Weightlifting and Powerlifting bars. Further, they have dual knurl markings...

"Harlem Air Shaft." The introduction consists of 12 bars, divided into three four-bar segments marked by key changes. The following 32 bars structurally...

(389cc) Vertical shaft GXV160 (OHV) (1987–) (163cc) GXV340 (OHV) (1986–) (337cc) GXV390 (OHV) (1990–) (389cc) iGX series Horizontal shaft iGX240 (OHV) (2010–)...

Shaft alignment is the process of aligning two or more shafts with each other to within a tolerated margin. The resulting fault if alignment is not achieved...

input shaft with 3 fixed gears which is mated to a secondary shaft with 3 gears fixed to the output shaft and 3 clutched gears mated to the input shaft and...

attached at a right angle to a rotating shaft by which circular motion is imparted to or received from the shaft. When combined with a connecting rod, it...