Jump to content

Bazzocchi EB.1 Littore

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Yamaguchi先生 (talk | contribs) at 00:22, 12 September 2015 (Design and development: Clean up, typo(s) fixed: Facist → Fascist using AWB). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

EB.1 Littore
Role Single seat trainer glider
National origin Italy
Designer Ermanno Bazzocchi
First flight 1936
Number built 1

The Bazzocchi EB.1 Littore (English: Lictor) was a one off, Italian single seat trainer glider designed and built by a university student in 1936.

Design and development

Ermanno Bazzucchi was a nineteen-year-old student at the Polytechnic University of Milan when he designed and built the EB.1. Friends from the University Fascist Group helped with its funding. It was intended as a simple and low cost single seat trainer glider.

The EB.1 was a high wing braced monoplane with a wooden structure and skinned with a mixture of plywood and fabric. Its wings were built around two spars and were aerodynamically thick; in plan they were unswept and of parallel chord, ending in asymmetrical elliptical tips. Ailerons filled about half the span. Mounted with about 2° of dihedral, they were braced to the fuselage on each side by a parallel pair of faired wooden struts which ran from the bottom of the fuselage to the wings at about one third span.[1]

The EB.1 had a deep sided, hexagonal cross section fuselage, ply covered forward and fabric aft. Its cockpit, immediately ahead of the wing, was open but the pilot was partly sheltered by a long streamlined transparency which photographs show to have been modified at least once. The tail surfaces were elliptical, the fin tall and the rudder extending down to the keel. Its cantilever tailplane, set at mid fuselage, was fabric covered and carried balanced elevators well separated to allow the rudder to move between them. A long, simple sprung skid served as the undercarriage.[1]

The EB.1 first flew in 1936 from a hill near Cantù, elastic rope launched and piloted by Bazzocchi. Only one was built.[1]

Operational history

Bazzocchi flew the EB.1 in the National University Contests (the Littoriali), held at the Cantù site. It later flew at Taliedo and Tradate.

Specifications

Data from Pedrelli (2011) p.201[1]

General characteristics

  • Crew: One
  • Length: 6.16 m (20 ft 3 in)
  • Wingspan: 14.0 m (45 ft 11 in)
  • Wing area: 15.20 m2 (163.6 sq ft)
  • Aspect ratio: 13
  • Empty weight: 120 kg (265 lb)
  • Gross weight: 200 kg (441 lb)

Performance

  • Maximum glide ratio: 18:1 estimated
  • Wing loading: 12.50 kg/m2 (2.56 lb/sq ft)


References

  1. ^ a b c d Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 200–1. ISBN 9783980883894.